No. I appreciate the try, but that tell tale is in the middle of the back of the motor and mine is on the side. The one I need is small and will fit thru a 5/16 hole.
I lost the tell tale nozzle for my 2017 Merc 30 hp outboard. I am unable to find the part number on the mercury parts diagrams. I have called/been to 3 different mercury dealers who say they cannot find the part either. Can anyone help me identify the part number of this item so I can try to...
Recently purchased boat with a 2017 Merc 30 hp. Had it out the other day and noticed it was not peeing water. No alarm was going off and engine seemed to be running fine. Brought it home and thought there was something in the the tube to the pee hole. Cleaned tube, put the muffs on it and it...
I have tried different trim settings. Currently I have the motor trimmed as far down as it can go to try to keep the bow down. The motor is a short shaft. I might be able to raise it up about an inch to get the anti cavitation plate even with the bottome of the boat.
I recently bought a Carolina Skiff J14 with a 2 stroke Yamaha 15 hp. With two in the boat, one in back running the tiller motor and one sitting up near the front deck, the boat will not plane. With just me in the back running the tiller the boat will struggle and struggle, but finally get up on...
I have a 1973 Johnson 65hp outboard. A few weeks ago I tried to start it for the first time in about 18 months. The engine won't turn over. I have removed the plugs and have been applying penetrating oil in the cylinders. I put a breaker bar on the nut over the flywheel thinking I should be...
Just had my 3.0 rebuilt. Got the engine back in the boat and the outdrive back on. Put the boat in the water and it started right up, with a little tweaking of the distributor cap, and ran fine as far as a fella could tell. I figured I should check the timing so got a timing light (I had...
I have recently purchased a Mercury 8hp to use as a kicker on a boat I am restoring. When I took the motor out for a test it went from shifting a little hard to now being unable to shift it out of forward gear. This motor has the shift control integrated with the throttle control via the...
I have a need to remove the cuddy floor from my 1986 StarCraft Islander. I need to remove it for two reasons; 1. It is rotten 2 I need to replace some rivets underneath it. I have started to drill out rivets and remove screws thinking I need to take out some of the benches in the cuddy as...
