I replaced my water impeller bus still won't pee. I unhooked the hose coming from the impeller but still don't get circulation. Could it be my thermostadts?
It is a 1999 150 hp fuel and oil injected. I hooked a fuel transfer pump to the fuel line going to the tank and fuel flowed great but as soon as I hook it back to the fuel pump and squeeze the primer I can hear air around the pump. Do you think I should bypass the primer bulb?
I have a 1999 mercury 150 hp efi outboard with a fuel flow problem. It was running about 2 weeks ago but has been setting since. I tried to start today but primer bulb would not fill up. I put a new bulb on but same thing. I removed the cowl and when I pumped the bulb I can hear air around the...
i have a 1984 ranger bass boat with a built-in gas tank that i just restored. i removed the gas tank and cleaned it. i replaced fuel lines, bubble and filter. i rebuilt fuel pump and carbs. now it is hard to get the fuel to the carbs and when i do it runs great but after i turn it off and it...
I have a 1984 mercury 115hp L6 2 plugs will not fire I replaced coils but still does not fire. wiring harness was cut when i got boat. I repaired the harness and it ran great only time out. came back home and now I cannot get fire to 2 plugs. changed plugs also. any help will be greatly appreciated
I installed a new faria fuel gauge and universal sending unit in my 1984 ranger 335v bass boat. when you turn on the ignition the gauge goes backward. it has about 12 gallons of fuel. what did i do wrong. thanks for any help
I bought a 1984 ranger 335v from a storage lot and am in the process of restoring it. there is what looks like a through hull transducer in the bilge but it doesn't look like it goes all the way through the hull. does anyone know what this is. also it has 2 slide levers to open and close...
I have a 1984 and 1973 115hp mercury engines. I need to know if the power heads and carberators are interchangable. I want to rebuild the 1973 power head and carberators for a backup for thwe 1984. Any help will be appreciated
I have a 1984 ranger 335v with a 115 merc tower of power. the hole in the back of the transom does not line up with the tube on motor. The rod is in a bind trying to push it through. Do i nee to remove tube or what. Thanks for any advise
engine cranks, runs and throttles real well but water is running out of the number 6 plug. am i in trouble? motor does not miss or knock. any advise would be appreciated
I am trying to find a wiring schematic for a 1984 ranger 335v. I bought an owners manual from ranger, but it is generic. I need a detailed wiring diagram
