Re: Evinrude 75 hp Model # 75743 Sport I would like to install a Tell tale
Alright got and update for you Iggy here are some pictures of mine done my local hardware store did not have the angled 90 degree 1/4 inch brass part i needed so I just put a straight port going up but need to get the...
Hello everyone Finally got the motor installed and hooked up changed the water pump and got it running. The day we were going out to test the motor I tested it right before going to the lake it fired up and run for 20 seconds and died. I had it running and Idling the day before for a good 15...
Hey guys just got this motor and I would like to install a tell tail on this motor i put in new water pump but would like to know saw on youtube someone installed a tell tail on this exact motor what parts do I need and how easy is it to do this any help would be great thanks
Re: 1986 Bayliner Capri repower with 1977 evinrude 75743S outboard
I took some pictures here they are
Check out that sunset on the last picture that was from the other night here we get the best sunsets during winter time that picture was from my front yard
Hey guys,
Alright I'm getting ready to repower my little boat and I havent measured but I am pretty sure the through the transom holes for my new motor will not line up. I will need to fill in the old holes and drill new ones what should I use to fill in the old holes PB or? and then before I...
Hey Guys just checked out this outboard and checked the compression it has 140 in all three cylinders. Is this a good motor? I see it was made for the salt water but I don't think it was ever in salt water. and does anybody know if it is a 2 stroke or a four stroke engine? Any info on this motor...
Re: Tbones Restoration of 1978 Bayliner Victoria Sundeck
I took a long time to finish my post and it logs me out here are the pictures
GWPSR there is you shower pan it is fully intact
Re: Tbones Restoration of 1978 Bayliner Victoria Sundeck
He really likes it, But the other day we went down to the river and he got stung on the rear:lol:. In the jungle the mighty jungle the lion sleeps tonight a winga whopp a winga whopp a winga whopp a winga whopp oo oo oo oo oo oo oo o oooo...
Re: Tbones Restoration of 1978 Bayliner Victoria Sundeck
Thank Zool Yeah I will get those numbers tomorrow for you guys I think I can get CRC Freeze off at auto zone
I've gone over your thread many times GWPSR and came to the realization that we have the exact same boat. Yeah they had some...
Re: Tbones Restoration of 1978 Bayliner Victoria Sundeck
I also took some pictures of some these numbers inside the cover on my out drive what are they? I will get the other numbers from above that show it is a DP-C and get that info tomorrow
Volvo Penta
872028 FA39312
Oh here is some pictures...
Re: Tbones Restoration of 1978 Bayliner Victoria Sundeck
Ok finally got back into the boat and
After I pulled the floor which was not attached looks like the PO had tried to do some repair with a sheet of fiberglass
Re: 1988 Imperial 280sf engine swap and restoration (pics)
Hey Zool just read your thread mind if I join in the fun? So funny I just finished fencing in the rest of my yard last night now I can get back to my boat. Nothing close to 3000' though. thanks again for all the info and yes salt water
Re: Tbones Restoration of 1978 Bayliner Victoria Sundeck
I've started to clean the outside of the boat
Here is what outdrive I have much different when cleaned up. Can anybody tell me what it is? It says DP Trim on it and the volvo emblem which I blew off with my pressure washer
I think the...
Re: 1981 Bayliner Victoria 2750 - Restore or Bust
Here is mine, and I am about to put some miles on it. It is a Makita
I had removed the guard but i will be putting it back when I start with the cutting disks
Re: Tbones Restoration of 1978 Bayliner Victoria Sundeck
Well it actually has never been started. Right now it is in a 1978 gmc motor home that was in a fire. The PO has purchased the motor/Trans from Napa Auto just finished wiring it in had it parked next to a shop and some kids lit the shop...
