Search results

  1. B

    What fuel pump do I need for an RD-19 35 hp '57 motor?

    Need one to fit cover plate. Thanks.
  2. B

    need part number for TN26 condenser

    It's a 5 hp green motor. Where can I get 2? I tried Marine Parts Outlet. Thanks.
  3. B

    1974 Sea King glass boat has spiderweb cracks on the hull

    They don't look deep. Is there an easy roll on repair method out there? Thanks.
  4. B

    Most likely place to get a pre-drilled cover plate for '57 35 hp Johnson?

    Need to convert the fuel system. I've searched and found information on do-it-yourself. Can't figure out how it seals the vacuum in. Anyhow where might I find a pre-drilled cover plate and fuel pump? Thanks.
  5. B

    What condensers for '57 35hp and 5hp TN26 sn#826304?

    A '58 uses a Sierra 18-5344 (580321). Is it ok for the '57? Need two for the 5 horse too. Not sure of the year. Thanks.
  6. B

    Can an electric starter be put on a '57 35hp Johnson pull start motor?

    If so, what is required? mounting bracket? Special flywheel? Thanks.
  7. B

    How do I take Delco starter off '88 Mercruiser 3.7?

    The problem is when I put a positive jumper on the big lug on the starter relay and ground the other jumper, it clanks, but the starter won't turn. If I could just back it out a bit and try it that would narrow down the possibilitys. I don't have nor know how to use an amp/battery gauge to make...
  8. B

    '88 alpha one cruiser J1171 -how to separate motor and pump?

    Some of the manuals posted wouldn't load on my W98 even though it said it was downloading. Both solenoids click, so I asume they are all right. The unit is in the up position so I jumped the green/white wire and it didn't go down. There are 4 screws going up into the motor and two going into...
  9. B

    Where is the coolant drain on 3.7 litre Mercruiser?

    I looked on both sides and found nothing. Is a 3.7 a 140hp motor? Thanks.
  10. B

    plug broke off in head of Merc cruiser

    We just got this boat as a project and the plugs were so thin in the middle that a slight twist broke one plug off with the bottom still in the block. There is another one that might do the same thing. It is a 4 cylinder Merc cruiser I/O. How are they taken out? Thanks.
  11. B

    Johnson 9.9 won't run much past idle

    This 1992 Johnson was bought new by the previous owner and used about 3x as a kicker motor. I've put about 20-30 hours on it. It idles ok but will onl start up on plane, even with 3/4 throttle. At full throttle it gags but keeps going. The compression is 100# on each cylinder The diaphragms...
  12. B

    9.9 cupt to starter washer substitute?

    The c-clamp popped off the starter and I lost the cup to starter washer #0318941. Would a regular 1/2" washer work? Thanks.
  13. B

    '71 18hp lost spark to both plugs

    Hi, I had this motor running for a few minutes, then it quit, no spark to either cylinder. One condensor was new. What might cause that to happen? Thanks.
  14. B

    '92 9.9 Johnson loads up

    This J10Rena model won't get a 14' aluminum fishing boat on plane like it used to. I put a new carb kit in, and checked the fuel pump. The diaphragms looked ok. At full throttle it reallys gags up until backed off a bit. I put sea foam in and ran it hoping to loosen any dirt in the carb but...
  15. B

    How to adjust '92 Johnson 9.9 gear shift?

    This motor goes into reverse and neutral but has trouble going into forward. Sometimes when you think you are in neutral, it is still in forward. When I get to the library I will get a manual but thought I would post it anyhow. Thanks.
  16. B

    Stuck prop on Evinrude 9.9

    I searched the posts on this but didn't turn up anything useful. This prop was off about a year ago, but it won't budge now. Both fresh and salt water.I forgot to grease it! Pulley pullers won't get a grip and a chisel type tool doesn't help. I can't hit the plastic on the back. Is there a...
  17. B

    need fuel pump kit for 18hp evinrude

    Evinrude only carries pumps and not kits for this 1971 Model 18102S 18 hp motor. Sierra doesn't have any kits listed either. Would a Sierra 18-7823 fuel pump kit work? Thank you.
  18. B

    Substitute fuel pump kit for 18 hp '71 Evinrude?

    Hi I've got a 1971 18hp Evinrude 18102S. There is a Sierra kit 18-7042 for the fuel pump, but it doesn't have the diaphrams included. Evinrude doesn't have a kit. Is there a substitute like 18-7823 that will work? Thanks.
  19. B

    Need J48ESLETE shift rod measurment

    Hi, I've got a long shaft motor and found two different lengths in two different manuals. The first didn't work. Anyone know the one in an OEM manual? Does anyone else have a problem getting the shat up through the hold at the top? I took out the seal, rand a wire with a clip on it then had...
  20. B

    Johnson '93 9.9 surge

    What would cause a 92 Johnson 9.9 to surge? It seems to be the worst when going at slow speed. It comes and goes. Sometimes real bad and sometimes not. Thank, Bob
Top