somebody asked about stainless steel props and the damage they cause. this was a Black Max outboard at full throttle meeting a boulder The other photo`s are too painfull to post
Narrative:
The CitationJet departed Burlington (BTV) around 14:45 on a routine flight to Atlantic City (AIY). The pilot first made a low pass down runway 29 and then return to land on runway 11. After touchdown the airplane failed to stop and overran the runway and into the Intercoastal...
Almost positive I know the answer but would like confirmation. A CR unit is CR because of the way it shifts. Meaning a STD or CR is determined by
how the control cables are installed. The upper gear set dosent know the difference because of the cone clutch.?
locate the center of the pin ,can be done visually
Drill in 3/8 ths of an inch with a #3 drill bit for 1/4 x 28 thread and tap .
using a 3/64 drill bit CAREFULLY drill approx. 3/4 to 1 inch into the housing until the magnet picks up steel shavings.STOP DRILLING. Install grease fitting.inject...
This only applies to those equipped with single point drain systems. This is the 3rd boat that I have found the block drains "blocked" with scale.
You MUST remove the quick connect hose and probe the engine block drain holes .
Failure to do this critical stem will most likely result in a cracked...
working on a 6.2 that would not get out of its own way, would only turn 3100 rpm. Cool fuel unit was replaced under warranty but fuel press was pulsating
42-46 psi . Suspecting bad injectors, they were remove and sent out for cleaning. 7 were in poor condition for fuel flow and balance.
cleaned...
Tech Tip with the single point drain system, be sure to remove the quick connect fittings on both sides of the block.
They do close with scale and corrosion . The same thing happens with the so-called flushing system. The block connection become closed from corrosion and will not allow it to...
Getting close to the close of another season so do it right or pay the price.
You CANNOT spray fogging compound into a fuel injected motor`s intake. you will ruin the sensors. You need to make up a small gas can with the winterizing cocktail and hook it to the fuel inlet. Gas, Stabilizer...
For those that have this pipe going from the exaust manifold to the intake manifold a very short natural gas whip dies the trick and comes with the correct threaded fittings too. and is stainless steel
Got to hand it to the engineers on this one. 3 year old boat with the new emission package, cats, etc. operated very well the day before, the next day it was a no start. no fuel delivery, no fuel pump pre-prime sound. Everything else worked.
All engine breakers checked, all ENGINE fuses checked...
crab cap wire order http://www.2carpros.com/forum/automo...ireorder_1.jpg
firing order for GM is 1,8,4,3,6,5,7,2 but that's not how the cap is wired. Did not see this mentioned in the manual and if you used the firing order it would not run right.
Like the title says, my buddy`s big block was acting funny. low compression , slight moisture issue. pulled the head and found the gasket blown between 2 and 4.
#4 intake lifter depressed about a 1/4 inch more than the rest.So new lifters and a head check coming.
What we did find that is worry...
