Search results

  1. dingbat

    nice show...great location

    Ya, reconciled the sailing center behind you Used to go just every year before it became a "thing". Kept the boat at a marina on Spa Creek. Anchored up in the shade of the Rt. 450 bridge.
  2. dingbat

    Good spray on weed killers.

    I can vouch first hand it doesn't kill yellow jackets, hornets or wasps living in fence rows.......
  3. dingbat

    nice show...great location

    Looks like Severn River
  4. dingbat

    Housekeeping PSA

    What system are you using that requires multiple units/sensors? The ones I’ve looked at monitored flow rates from a single, whole house point
  5. dingbat

    Battery Cables

    Put new battery cables on my 200 hp last year. The 6’ OMC positive cable was 4 gauge. Best place I’ve found for making custom cable assemblies https://www.customcableusa.com/
  6. dingbat

    200 HP Evinrude/Johnson Carb Kit and Rebuild

    I would rather spend an hour, hour and a half every 5-6 years changing gaskets than spend almost $250 a tank (150 gallons) more for E0 at the marina and then have to deal with moisture issues again. There are gasketed pockets for the mixture screws on the side of the throttle bodies. Plates...
  7. dingbat

    A wiring question

    A boat is no place for 22 awg wire.
  8. dingbat

    question on power steering ram

    Don't know where your located, but McMaster is overnight delivery to us. A local hydraulic supply house would have what you need
  9. dingbat

    How Dumb can a dude be????

    People get funny selling items on-line. Could be he doesn't want you to know his real location. Had a guy who wanted to met curb outside at his home. Thought is strange, but OK Dummy didn't think about his real address being on the title. The guy actually lived 2 blocks down the street.
  10. dingbat

    1996 Yamaha 250 hard start after sitting on water for a while

    Hot is relative....... E10 can "boil" at 149F depending on the pressure. The boiling point of E0 (Regular 87 octane) is ~185F Try letting the engine idle a bit to cool down before shutting off. Try running E0 and see if that helps
  11. dingbat

    200 HP Evinrude/Johnson Carb Kit and Rebuild

    It's not if, it's when the carbs need attention. I've never had any issues with the "spaghetti" gaskets, but even the viton (brown) bowl gaskets and float needles don't make it more than 5-6 years before they start leaking/seeping fuel and need replaced. The nitrile (black) gaskets and needle...
  12. dingbat

    Audio Warning Alarm weird problem on 2001 4.3 Mercruiser EFI MEFI 3

    Couple of things… Can’t assume they’re switching ground to initiate an alarm. Alarms typically have multiple dependencies. Pull the wire from oil sensor while running
  13. dingbat

    question on power steering ram

    Unless they did something crazy, the “seals” are just o-rings. Tear the cylinder down and measure the orings. Go to local hardware store for replacements
  14. dingbat

    200 HP Evinrude/Johnson Carb Kit and Rebuild

    Rebuilt mine last fall. Didn’t need cleaned. Running E10 carb bodies perfectly clean Jets very short. Just blew out with air Manual gives you a “base” number of turns. Will need to make final adjustments on the water Seats and needles wear over time Why not? Takes all of 30 seconds to bend a...
  15. dingbat

    Good spray on weed killers.

    The concentration of the “pre-mix” sold in big box stores are bare minimums. As noted above, must be applied while the target is dry or add a surfactant into the mix. I have two, five gallon containers of Round Up concentrate out in the garage that I use around the farm. At one tablespoon of...
  16. dingbat

    Birds in the boat . . .

    Yep…pesky little rascals. Had one build a nest on the ceiling fan on the screen porch last year. Used the “cat door” for access
  17. dingbat

    1999 Johnson 200hp, Ocean Runner Lower Unit Hub

    According to the manual, when installing a new thrust bearing, or washer, bearing housing, pinion, or drive shaft, it is necessary to properly shim the assembly to restore factory clearance. Gives very specific instructions on how to measure and shim the length of the assembly. Having said...
  18. dingbat

    N Y requires everyone to pass a powerboat operators license

    According to USCG records accidents had been on a downward trend for a number of years prior to Covid, then spiked again. Top causes of accidents per USCG 1. Operator inattention 2. Improper lookout 3. Operator inexperience 4. Excessive speed 5. Machinery failure 6. Navigation rules...
  19. dingbat

    1999 Johnson 200hp, Ocean Runner Lower Unit Hub

    You’ve changed shafts. Did you following the shimming procedure in the manual?
  20. dingbat

    BMW headlight . . . $1,000 !!!

    If it’s like mine, it points the head lights in the direction of the steering wheel. New headlight unit is $800
Top