Search results

  1. briangcc

    Fish Finder Menu Map

    I think the OP is looking for an owners manual that says something like.... To adjust the screen brightness, press button 1, followed by button 2, then button 1 again.
  2. briangcc

    Free boat with history of leak... worth it? Will a survey catch issues?

    Well.... You could take it on, then do due diligence to determine where the leak was and how far the damage is. Then if needed, scrap the boat and sell off the trailer for a bit of $$. But for me and my family....it wouldn't see or sniff water before I determined it was structurally sound...
  3. briangcc

    Boat budget question

    Could get a quote from a pro. Then pay yourself for each hour spent in labor... Adds to the boat funds right?
  4. briangcc

    Bayliner Floor Project

    If the floor is soft, the bulkheads are cracked, there's every chance the motor mounts are suspect and the transom is toast. You got lucky the last time you were out. What are the chances that luck is going to continue without rebuilding the major structural components of the boat...
  5. briangcc

    Back for More! Looking into a bigger boat for big water - Deck or other

    I'd suggest a center console but you're looking at a tow vehicle upgrade. Toon will do fine provided the St Lawrence river is calm. When it kicks up, and it will, you will want something else that can handle the waves...or even that from a passing freighter.
  6. briangcc

    What's your best "MacGyver it" boat, non-boat story?

    Way back when...you know when AMC made the Eagle, first 4x4 car? My grandfather, GM fleet mechanic, had one and took it to CT. Well the engine mount failed. His solution? Find some of the tire scraps along side the interstate and lob it in there to keep the engine from rotating in the engine...
  7. briangcc

    Bayliner Floor Project

    I have Seadek on my swim platform. Installed in 2018 and only have a few spots starting to lift. I may "limp" it by with some 3M double sided adhesive tape as it was rather costly to have custom made. Other than that, there are no rips/tears in it whatsoever. Easily a good 20 degrees cooler on...
  8. briangcc

    Finally happened Toasted a T-motor $$$

    Mine came with a Motorguide. Seals started going a year or two ago. I'm going to run it into the ground then replace. Everything I've seen for my setup is either fob or foot pedal controlled and into the $1k price range. Depending on where that's manufactured...tariffs might come into play so...
  9. briangcc

    What kind of damage from an I/O in salt water for 2-3 years?

    Boat house?? I could see that happening. At least they're fairly prevalent up in the areas I frequent.
  10. briangcc

    Required Safety Course

    Just went through the NY class. NY will honor (reciprocal) a FL card as long as you are in state less than 90 days. That covers the snowbirds for the most part. As this is the first year where a boaters safety cert is required, our instructor mentioned to be prepared to be stopped and asked for...
  11. briangcc

    Trailer sounds like chain is dragging but nott

    Bearings / brakes. Had a bearing go on an Escort trailer. Didn't know it at the time but at low speeds, the trailer shook hard enough the trailer jack would rattle. Died down at higher speeds - go figure. This was way back in my younger/stupider days. Cost me an axle by the time I had the...
  12. briangcc

    Bayliner Floor Project

    On the exhaust, I might check into putting it back through the outdrive. This based on what I was told during my safe boating class this past weekend where in NY if you are deemed too loud, you can be cited and pulled off the water. Instructor made a point this was going to be an enforcement...
  13. briangcc

    Brake woes

    Damn. This is one where I hate being right. On a Sierra 1500, I went through 3 different shipments of Powerstop rotors (about 15 years ago) cause they kept sending the wrong rotors. I had 6 bolt lugs and the rotors were 5 bolt. Don't ever get these, the drilled/slotted rotors delam'd in under...
  14. briangcc

    Brake woes

    Manufacturing defect with pads or rotor. Don't ask how I know this... Rock Auto may you rot in.....
  15. briangcc

    Don't tape holes.

    Goo Gone or Goof Off usually makes very quick work of adhesives. I've used that several times to clean off shrink wrap tape from previous winterization. Going to be re-doing my reg numbers this year as the cheap home improvement store lettering is falling apart.
  16. briangcc

    My 84 4winns horizon 195 project.

    I'm going to lean on another hobby of mine...aquariums. Stay with me for one hot minute... The lids to glass aquariums usually are glass, and have a plastic hinge. You can get that hinge in black or clear for various thickness glass. That's where I would look. It'll more than likely be narrower...
  17. briangcc

    Need some help

    All set. Thanks for the help!!
  18. briangcc

    Does winter cause odd purchases ?

    Other than fishing lures? Nope. My wife escorted me out of the big box chain boat section though. My son was oogling over a $90k boat so I asked him to look down the side of the boat. It was rippled at every blasted weld mark. Told him for that price I wouldn't be buying a pre-dented boat...
  19. briangcc

    Bilge blower question

    I know my Bayliner in my signature didn't have a blower. That had a 20gallon built in gas tank. I think though the tank & lines were under the rear bench seat which was directly open to the air....been a few minutes since I owned it :)
  20. briangcc

    Glastron GS-249 Owners Manual

    https://www.glastron.com/uploads/2017/3/Glastron-Owners-Manual.pdf Might get you close. Otherwise, they claim to be in business still, although I'm hard pressed to find any local dealers to me...you can try calling.
Top