Search results

  1. Faztbullet

    Need lower unit 2004 mercury 115 OB

    You cannot just swap parts into a different case, it would have to be all reshimmed
  2. Faztbullet

    Ignition Compatibility on 150hp Blackmax

    Looks like a 1994-96 Xr4 with old style cowl and early front air silencer
  3. Faztbullet

    Ignition Compatibility on 150hp Blackmax

    1984/85 2 liter..starter date code is 1985 and WH-29 are150 carbs
  4. Faztbullet

    Need help

    Sorry but no
  5. Faztbullet

    Carburetor's

    Timing is 0°-4°BTDC
  6. Faztbullet

    2005 90hp 2 stroke cdm wires are wrong?

    If its wrong it wont run and possibly backfire,
  7. Faztbullet

    2005 90hp 2 stroke cdm wires are wrong?

    From the manual..Looks like they (MERC) started change in late 90's
  8. Faztbullet

    2005 90hp 2 stroke cdm wires are wrong?

    Should be fine as the wiring shown is for engines with 132 firing order and yours is a 123
  9. Faztbullet

    1978 Mercury 700 3 cylinder fuel pump

    They were water cooled if effort to reduce vapor locking
  10. Faztbullet

    1987 v200 black max wont go over 2000rpm

    If switchboxes are not OEM, Serria, CDI or Prufrex they can be bad and act good due to bias circuit. I have had 4 customers return the Amazon Chinesem junk this month and I replaced with Serria (warranty)
  11. Faztbullet

    Driveshaft won't move with lower unit removed

    Did you pull the lower base? If so you may have lost shims and now base is binding the upper bearing.
  12. Faztbullet

    j200txeoc JOHNSON wont start

    Crankcase dried out......pump up bulb till hard, move red level and squeeze bulb 1 time, return level to original postion, start engine and use key by pushing in to keep running till warmed up
  13. Faztbullet

    Copper crush washers ok to use?

    Use the Merc yellow washers as they are reusable,dont deform and I use them on all my customers with no leaks.
  14. Faztbullet

    Diode installation on 1972 Rude CD Ignition

    Can you get a spark to jump a gap from the coil only? If not you got problem with CD output. The OMC start upgrade was to run a wire from the white wire (key switch) from solenoid to 12v ignition wire from key on CD unit. The diode is placed inline on the jumper wire to prevent feed back to...
  15. Faztbullet

    Engine building tip regarding gel-seal?

    Build all my V4/6 loopers this way :)
  16. Faztbullet

    Mercury Tilt and Trim units

    So you just need a body and trim rods?
  17. Faztbullet

    Prepping heads/block for new gasket

    Short piece of 2x4 and 220 grit makes a good sanding block for this.
Top