Search results

  1. pvanv

    Tohatsu. 2.5hp 4 stroke lower unit jammed

    Sounds like shifter is mis adjusted.
  2. pvanv

    Engine cutting off

    Probably a bad o-ring in the primer hose.
  3. pvanv

    Power tilt fluid refill

    use ATF. Fill while tilted and then cycle it and then refill.
  4. pvanv

    2002/2003 NSD70A2 Nissan 70HP TLDI remote control / console gauge wiring question

    Whip out your Factory service manual and the owners manual for help.
  5. pvanv

    Break in oil

    Yep. Use NMMA rated FC-W 10w-30. Verify 1/2 way on dipstick.
  6. pvanv

    Tohatsu throttle problem

    I would definitely check inside the carb.
  7. pvanv

    Tohatsu throttle problem

    Model 9.8A3? Is it so rich that the full throttle gives it enough air to run? What do the plugs look like?
  8. pvanv

    Nissan 9.9 help

    Ugh. Round float carb, or octagon float? Sounds like flooding. Some individual parts are still available. I would verify float height first.
  9. pvanv

    2.5HP Mercury/Tohatsu/Nissan Outboard No Longer Starting

    I would move the clip down, to raise the needle.
  10. pvanv

    4 HP Nissan Flushing Plug

    Any Tohatsu/Nissan/Mercury/Evinrude dealer.
  11. pvanv

    ns50c timing specs

    If you didn't change them, they should still be correct. I don't know the numbers off hand, but I think that stuff is in your manual.
  12. pvanv

    70hp tohatsu running rough

    I vote for a proper carb cleaning.
  13. pvanv

    2.5HP Mercury/Tohatsu/Nissan Outboard No Longer Starting

    There are 3 settings for the needle. Depends on where you install the clip. Also a screw to set idle.
  14. pvanv

    ns50c timing specs

    Look at p3 for the info.
  15. pvanv

    ns50c timing specs

    I think you have all the info you need.
  16. pvanv

    No spark

    Any dealer...
  17. pvanv

    2.5HP Mercury/Tohatsu/Nissan Outboard No Longer Starting

    What is your actual model (not year?)
  18. pvanv

    Tohatsu 2007 TLDI

    For shift, yes. For electrical, no.
  19. pvanv

    Follow-up on previous thread/issue

    This is on that 9.8A3? Fuel ratio is fixed. The 2 carb gaskets should have a plastic spacer between them. What do the plugs look like? I take it they are NGK DCPR6E plugs...
Top