Search results

  1. C

    Stalling at Idle and Idle Speed

    OP said fuel pump was "tested... by EV mechanic". symptom still indicates possible bad pump if " hand pumping" steadies the engine !
  2. C

    Stalling at Idle and Idle Speed

    engine mdl # ????
  3. C

    2014 Evinrude KNOCKING sound

    I noticed there is oddly some oil on/in the inside of the air intake box seems strange .... just my humble opinion...ETEC oil is directly injected inside the engine and none in the fuel for your model (early ETEC had "oil in fuel injection" but stopped around 2008) faulty reed valve...
  4. C

    Johnson Outboard Motor MODEL NO J30PL4SD 4 Stroke 30Hps Stalls after 20 minute use, then restarts after waiting 5 minutes

    restarting after a 5 min. period would seem to indicate some form of fuel flow problem impacted by poor venting and a vacum build up that eventually clears out. the alternative imho would be an electrical component fault caused by a high temperature intolerance eventually cleared...
  5. C

    2013 Etec Steering Question

    anything ETEC can be asked on the ETEC board... what does Can you tell me ehst the title is? mean....
  6. C

    2013 Etec Steering Question

    see answer on the ETEC board...
  7. C

    2013 Etec Steering Question

    download 2012 book from this iste ... it may help https://drive.google.com/drive/folders/1-pyBmXzRaZ16y9sJ1QkSfjnBGwA-HzsB
  8. C

    1974 9.9 Johnson running problems. I can get it started but then runs very ruff.

    if sparks ok sounds like crud ending up in the carb... maybe just a bad grey hose plugged tank pick-up, venting etc... sometimes badly stored engines end up with dried out fuel and running them years later loosens all that " varnish" and plugs the carb. time to take it apart.
  9. C

    Recoil spring spun in housing

    make certain rope lenght is per specs
  10. C

    Johnson Outboard Motor MODEL NO J30PL4SD 4 Stroke 30Hps Stalls after 20 minute use, then restarts after waiting 5 minutes

    if not fuel flow related try cooling down any suspect component to see if the restart time shortens.
  11. C

    No spark on half the motor!

    https://maxrules.com/graphics/omc/wiring/82_83_V6.jpg swapping cd units maybe a qwick easy test . melting coils doesn't sound good
  12. C

    Gale 7.5hp Montgomery Ward Sea King

    see post #2
  13. C

    Need help with strobe timing on 1972 9.5 HP Johnson 9R72M

    fyi
  14. C

    Timing off due to throttle arm and cam follower?

    deleted
  15. C

    Need help with strobe timing on 1972 9.5 HP Johnson 9R72M

    Water in the can gets very oily..... lots of fresh fuel and oil... goes out the window when entering the cyl on the upstroke.... making bucket water " oily" . that is why fuel injected engines are so efficient. normal for 2 strokes
  16. C

    Gale 7.5hp Montgomery Ward Sea King

    mdl# ?
  17. C

    1973 4hp Evinrude

    points gap is not to important what is important if points opening at the right instant
  18. C

    89' johnson 90 not charging

    2 vac out the stator is never going to give you 12v+ regulated charge current for the battery. presumably you measured 2 vac with rect/reg connected try reading just the yellow AC stator volts ouput without the rect-reg. charge current goes up with rpms
  19. C

    Evinrude 1999 225 Code 44

    depending the the ECU (EMM) they are water cooled so water presence is normal...suggest you download FICHT related books from this site. not all appicable to you but they provide some.. info on FICHT operation ex;: the 2002 and up FICH/ETEC manual...
  20. C

    1985 Evinrude 15 HP trouble starting

    a bit wet should cause explosions on the lower cyl... recheck for good sparks and don't flood the engine with to much choking remove plugs and ground them to the chassis.... have a buddy pull start it and check for snappy sparks. use fresh fuel. try openning up the top IDLE...
Top