Search results

  1. J

    Ethanol treatment

    Its all new and modern...I burn through gas as I use boat alot
  2. J

    Vaccume gauge info

    My vaccume gauge reads about 17 inches at idle...doesn't bounce around...now when I'm cruising at about 3000 rpm it's at a steady 10...sound about right?
  3. J

    Ethanol treatment

    Kinda figured that would be the scenario but worth the ask
  4. J

    Ethanol treatment

    Looking for advice on a treatment product to reduce ethanol...our gas price for anything that doesn't say may contain 10 percent is outrageous.
  5. J

    Oil filler cap filter

    Right o...thanks
  6. J

    Oil filler cap filter

  7. J

    Oil filler cap filter

    I could plumb one into the bottom of the spark arrested if needed...I can't get a thicker one due to clearance from the floor
  8. J

    Oil filler cap filter

    I don't no....can I run a breather cap or shoukd I change it
  9. J

    Oil filler cap filter

    My oil cap in valve cover has what appears to be filter material in it...it drips some oil ...not much but I did notice it...should that cap have a vent hose to flame arrester or shoukd I just clean it or replace it
  10. J

    Mc-1 upgrade....

    My 302 is new so swapping out to sbc isn't in the cards
  11. J

    Mc-1 upgrade....

    I was hoping to just change the outdrive...pull the 6 bolts and bolt on something newer....
  12. J

    Mc-1 upgrade....

    I want to upgrade my oudrive. Boat is a 1975 with a 302 v8. The outdrive now is mc-1. What is best and easiest direct replacement on a budget...
  13. J

    Anchoring question

    Ya it's a months work out lol
  14. J

    Ford 302 exhaist leak sound

    I have developed what sounds like an exhaust leak however only when boat is in the water...not on muffs. All the gaskets and elbow gaskets have been replaced..any ideas
  15. J

    Anchoring question

    I anchor in the tidal portion of the fraser river so on an outgoing it gets going pretty good
  16. J

    Anchoring question

    I anchor in about 30...to 60 feet of water...that's alot of rope
  17. J

    Anchoring question

    I wasn't sure were to post this...my question is what size rope to anchor a 21 foot cruiser boat. My river anchor is about 40 pounds and I anchor in the river
  18. J

    Cooked my impeller

    I also ran a wire up threw each hole on the back of transom plate and port side went way further then other
  19. J

    Cooked my impeller

    Installed new impeller and pump assembly and had great flow from back of boat...took boat out and it ran great...I did random heat checks with my ir gun. All was good....ran boat on muffs and I had more flow on port side and very little out the other. My manifold heat was climbing so I shut it...
  20. J

    Cooked my impeller

    Got it thank you
Top