Search results

  1. J

    Ford 302 exhaust elbow

    The new engine is in and mounted.
  2. J

    Ford 302 exhaust elbow

    I will add that my outdrive is in and all sealed as in bellows and gaskets
  3. J

    Ford 302 exhaust elbow

    My engine isn't ready to use. I have not hooked up my exhaust manifolds or elbows. Y pipe has new flappers. Is it possible to use boat with the kicker or will my boat sink
  4. J

    2001 yamaha 9.9

    Here is pic...it's the top outlet I cannot blow air through
  5. J

    2001 yamaha 9.9

    Winterized kicker and had good tell tale. Just installed it back on boat and no tell tale...I can blow through the hoses except the top hose port. Also curious if I should get the wash fitting on the side. Will that push more water then using muffs. Not sure how it does not pump now
  6. J

    Mc-1 wont go all the way

    Thank you for the help....outdrive slid right in.
  7. J

    Mc-1 wont go all the way

    Perfect thanks...I.got it in all the way by tapping the tool around a bit
  8. J

    Mc-1 wont go all the way

    Problem is the bar doesn't go in far enough to make marks in the grease
  9. J

    Mc-1 wont go all the way

    Not sure how to find that
  10. J

    Mc-1 wont go all the way

    I have tried spinning it as well...tomorrow is a new day...may just slide in. I've never had this much trouble
  11. J

    Mc-1 wont go all the way

    It goes in to were my finger is easy
  12. J

    Mc-1 wont go all the way

    I've been fighting this leg for couple hours now. New engine installed...all mounts the same. I tried engine alignment tool however I don't think it's going all the way in.
  13. J

    Timing cover

    Here's the pics
  14. J

    Timing cover

    Good day. First issue with newford302 engine. The new timing cover does not have 2 bolt holes for alt bracket. It's already installed as well as the pulleys and water pump. Is there a bracket for alt that will bolt onto water pump and timing cover.
  15. J

    Ford 302 thermostat

    There is no bypass valve and my last one had it. Does that matter or shall I drill a small hole in iit
  16. J

    Ford 302 thermostat

    Numbers on back are 8m6003555. Is this correct. It is 160 degree and quicksilver
  17. J

    Ford 302 thermostat

    Right o thanks I will get the real deal
  18. J

    Ford 302 thermostat

    Ok...so is there a difference between vehicle and boat
  19. J

    Ford 302 thermostat

    Good day. I am wondering on what to use for my thermostat. Boat has closed cooling. Any suggestions or a part number so I can get the right one
  20. J

    Temp sending unit

    It's a ford 302 and I got it from lordco. I went to my marine dealer as well and it seems impossible to find the same one that I had
View older results
Top