Search results

  1. Dukedog

    Mercury Alarm Codes…

    are you goin' ta pre-mix?.. tha only "alarms" that merc has is oiler and over heat... oiler will be oscillating beeps (unless module goes south) and over heat is a constant beep... so why do you want to "disconnect" oiler warning?
  2. Dukedog

    What Is everybody using for spark plugs

    tha HW's will be fine..... Tha X is really for high compression and high output ign. system
  3. Dukedog

    1990 Mercury 2.4 175 - water diverters

    (y)
  4. Dukedog

    1990 Mercury 2.4 175 - water diverters

    https://www.screamandfly.com/attachment.php?attachmentid=506494&d=1644074272 blow it up and you can see tha 4 large dots that are NOT labled... tha dia is for tha 280 but tha diverters are tha same....
  5. Dukedog

    Quite alarm going off 175 Blackman v6

    (y)
  6. Dukedog

    Mariner Idle Stabilizer - Spark Advanced Module

    naw.. jus chunk it... its supposed ta keep tha motor from dyin'/bring it back ta normal idle if ya chop tha throttle instantly.. ya might wanna check timin' (mainly wfo) if ya do get rid of it...
  7. Dukedog

    Quite alarm going off 175 Blackman v6

    also.. do you get tha three self check beeps at key turn on?.. if not thats an indicator of faulty module also...
  8. Dukedog

    Quite alarm going off 175 Blackman v6

    any kinda "constant" alarm at key turn on, motor not started its more than likely tha oiler control module.. you can disconnect tha purple goin' ta tha module and it should stop... that module's soul purpose is ta make any kinda signal it receives "ossilate".. if its comin' on constant instantly...
  9. Dukedog

    Mecury BlackMax 175Hp, Constant Beep and Overheating

    an "instant" beeeeeeeep is usually a bad oiler module... disconnect tha purple feeding tha oiler module or disconnect tha tan coming from tha oiler module at tha small term block on tha starboard side.... or both.
  10. Dukedog

    Mecury BlackMax 175Hp, Constant Beep and Overheating

    this pretty much tells ya its a pressure issue between tha pump and tha block.. when you had tha pump apart did you look into tha void under tha pump where tha intakes are?.. are you positive that tha plastic "guide tube" is doin' its job with tha copper tube alignment?.. was there a rubber...
  11. Dukedog

    Mecury BlackMax 175Hp, Constant Beep and Overheating

    99.9% of all production 2.0, 2.4 and 2.5's have 143* stats.. they all work tha same.. you say you are goin' by "feel".. thats no wanno. 140+ degrees is pretty warm.. you can get yourself a cheap heat temp gun to get real time reading on tha motor.... are you getting a constant...
  12. Dukedog

    Mecury BlackMax 175Hp, Constant Beep and Overheating

    did you do tha complete water pump kit or jus tha impeller?.. if it works with a direct hose and not with tha gear case pump then it sounds like a supply problem???... how hot is "hot"?.. does it alarm?.. need a pressure gauge.. makes life easier.
  13. Dukedog

    98 Mercury 150 XR6

    i can't recall ever tryin' any 'lectric part that was outta spec... if it was not up ta spec it went in tha trash bucket instantly... thats tha way shops get **** screwed up...
  14. Dukedog

    98 Mercury 150 XR6

    yeah, triggers can be one of tha more finicky (but dependable) parts in that type system... we always kept a known good one around jus for this type of scenario... gl.
  15. Dukedog

    98 Mercury 150 XR6

    replace tha trigger....... outta spec no waaayno no mater how small or large...
  16. Dukedog

    cannot get fuel to prime to engine. 1994 ranger 361v

    (y).... more important ta know than tha boat info!!!
  17. Dukedog

    Mecury BlackMax 175Hp, Constant Beep and Overheating

    when ya guessin' with an over heat problem and no pressure guage... replace "complete water pump"(not jus impeller), poppit kit and replace both t-stats... its relatively cheap maintenace anyway... then install a guage....... jmo.
  18. Dukedog

    Mecury BlackMax 175Hp, Constant Beep and Overheating

    do you have a water pressure gauge?... if so need readings at idle, mid range and wfo.........
  19. Dukedog

    Lower unit compatibility

    if its tha small case it was changed somewhere down tha line.. 4 1/4" outside ta outside... tha small case only came on tha XR4 and 6... it will also be a 1.78 ta 1 gear.. if your rig is propped for that ratio and hub size it may present a slight problem with performance with any other ratio and...
  20. Dukedog

    Lower unit compatibility

    your case is a 2 ta one.. if you buy used ya will need ta know how to determines what tha ratio is by turns of tha drive shaft to turns of tha prop shaft.. tha drive shaft wiil turn 2 revolutions to1 prop shaft revolution.. your serial number doesn't give shaft length but would guess a 20"?...
Top