Search results

  1. F

    trailer tires

    Don't remember off the top of my head about radial or bias. But I think I got d rated "trailer tires" I can look tomorrow BUTTTTT as far as Nanco tires..... junk! On one of the coasters I would work on we would use Goodyear tires and they would last about 4-5 years. Purchaser in tool crib tried...
  2. F

    power pack testing

    Got one of those above my desk. Used to have to use it to calibrate takeup servo motors in imax film projector. My digital meter was too sensitive. Got rid of the projectors and now it sits and collects dust
  3. F

    1984 OMC 200HP compression

    And you can verify rings with a squirt of oil. If after getting a low reading a bit of heavy oil, enough to cover rings, and if compression comes up some.... the oil slows air. bypassing the rings. Do all three and you will know the answers
  4. F

    can someone let me know what fuse sizes?

    Here is an ampacity chart. You want your fuse to blow before exceeding the ampacity of the wire if it's dead shorted. Then from there you step down again to protect the device from burning. If you have a 10 amp device you run a wire to carry 15 amps and fuse at 10 amps for the device. If your...
  5. F

    Wheel Bearing Inspection Interval

    Work on roller coasters and that's about all we use is American made timkins when possible
  6. F

    Chain locker bulkhead re fitting advise please (with pictures )

    Tabbing does more than just attach itself.... So as your tabbings Get wider, the joint flexes more. Like a leaf spring pack. you want to minimize that sharp edge so when the hull flexes, it flexes gradually. Not at a sharp 90deg. If i explained that goodernuff... bed the joint however and...
  7. F

    trailer surge

    Does your ride control have a dedicated fuse you can pull
  8. F

    1962 Chris Craft Holiday 20’ bucket list resto

    Hose- dull screwdriver and channel locks . Gently work screwdriver in and around while also gently working hose back and forth with channel locks. Eventually ot will break free as you get deeper. Dash- looks worse than mine did and I had more stuff
  9. F

    Rehab SportCraft 222 1983 deep V hull cuddy walkaround

    Slow poke for sure. ...... Almost as slow as me!
  10. F

    2.3 Lower Gearcase

    We use oilite bushings alot. There is a site called selflube dot com. They have good examples and sizes
  11. F

    Wiring for oil sensor

    Here is my guess blacks are both negatives and colors are from senders. Put a meter on the pairs and verify. Red and black pair 1. yellow and black/yellow pair 2. If they are bulbs it shouldn't matter direction. Leds would Just guessing
  12. F

    Chartplotter/FF Wire size

    5 amp load would be 12 g for 3% drop and 14 g for 10% drop at 25 feet
  13. F

    Chartplotter/FF Wire size

    You could probably get away with 10 Guage cuz you would be close and it's not a motor load
  14. F

    Chartplotter/FF Wire size

    Find the full load amperage of your device. Take that number and times by 125% and that's your required demand at the device. Then use this chart to Guage wire size. So let's say it draws 10 amps That would be 12.5. round up to next column would be 15 amps. Using 3%voltage drop and 25 feet of...
  15. F

    Wrong name

    That is a hilarious..... I never or didnt even notice the date. The aol is my go to email address and the one my brain defaults to. I am logged out of jruka on my new device so if you wipe that whole account I will fix my preferred email after you clean up my mess Thanks
  16. F

    Wrong name

    @colonel_sanders Well I got a new phone and did the same thing and have the same issue. I am banned on my new device again. Can this issue be resolved. I think what we did last time was unban jruka so I could logout of that account and log Into the right account. Then can I get this wrong...
Top