Search results

  1. F

    Lag Bolt Hole Striped (Engine Mount To Hull)

    You could make a 1/4 inch thick dowel piece, drill a hole in it like a washer and glue that in. It will eliminate a void to collect water. Glue in, sand flush and when you install if you use a bit of 3m 4200 it will be sealed frim water
  2. F

    Rehab SportCraft 222 1983 deep V hull cuddy walkaround

    On the edge of my seat biting my nails..... how does it end:unsure:
  3. F

    Welcome Back!

    Not to put more on your plate buttttt......... A setting to flip the order of the posts to put last post first/first post last Just an idea:) Fyi i was able to log in first time just fine
  4. F

    Electric shift stringer trim pump setup

    I am adding a trim setup to my ford/omc 190 hp drive. I have 2 different manuals and neither have the hydraulic schematics. I have the pump, both Ford rams and all the brackets. I also got some lines but they are bent and broke so I can't tell how they were routed. There are 2 ports on the pump...
  5. F

    proper fuel tank install......

    i felt froggy so i am going to leap on this one! thanks kcassells. this is strange doing this on a computer, i am a phone guy. i have read "yacht survey fuel tanks install" ~ 4 times. i have read alot of posts here and on other less worthy forums.etch with alodine, paint, dont paint, open air...
  6. F

    Add trim assembly

    I have 1972 reinell 21 foot cuddy with omc 190 & electric stringer. I am in progress of floor and stringers replacement. It didn't come with trim assembly. Before I get this all glassed together if I wanted to add the trim stuff how hard is it to add and is it possible....
  7. F

    Quick transom stripping

    Bottom 6" of my transom was rotten. The rest was good wood and for the most part bonded well. I cut the first section and started to peel. Took forever and was unable to separate the last ply from the glass. So I broke out the 9" grinder with a 24 grit pad on it and sanded and sanded .......3...
  8. F

    1974 reinell cuddy restore

    So here is the beginning of my journey. The sucky thing about this is the back of this boat was redone, had been in the water ONCE and then stored improperly. It doesn't seem that bad though. I have read back about 280 pages in the restoration forums on topics that either pertain or interest me...
  9. F

    Page selection

    I understand that the site is getting upgraded.... so fyi..... there is no longer a spot to select a specific forum page. I had worked thru all 290 ish omc pages and was working down the restoration forums and was to page 152 when I did the logout login reset thing and lost my current page so...
  10. F

    74 stringer electric shift rebuild

    I am the proud new owner of a once used boat trailer. it came with a free 1974 21 ft rinell cuddy w/ 190 hp ford 302 and I was told it couldn't be restored..... challenge accepted! the owner was replacing the carpet and it sat..... 10 years. it was a salt water boat. so first I have read...
View older results
Top