Search results

  1. J

    Water coming into bilge

    Just to confirm what I think I already know the answer....filled the bilge with water...water coming out of exhaust..so I'm assuming y pipe connector
  2. J

    Ford 302 rad cap temp gauge

    Also noticed I have about double the flow out of one side. Not sure why but it's way more
  3. J

    Ford 302 rad cap temp gauge

    So here's my findings with the temp gun. Ran up to temp...hx 170...manifolds 170ish..few degrees different from side to side...elbows were 95..100...block 150. This is running on muffs...I will check it all next time I ead out
  4. J

    Why is my carb oxidizing????

    I run mostly salt...haven't seen that much corrosion on anything
  5. J

    Ford 302 rad cap temp gauge

    Right o...I will order one....thank you
  6. J

    Ford 302 rad cap temp gauge

    I haven't got one...temp gun right
  7. J

    Ford 302 rad cap temp gauge

    I put a cap gauge on hx...here's a pic of temp from about a 15 min run..fluid goes into barf can and then back as it cools. Does this temp seem alright..it hasn't went any hotter
  8. J

    Raw water flow

    Ok I will get diggin
  9. J

    Raw water flow

    What I meant is the tiny hole on the right side only
  10. J

    Raw water flow

    Ya mine is pretty close to that..little less maybe. I see a solid stream coming from the lower unit on the right...I see that hole on mine but I believe it's plugged now that I see that...drill it out or what best
  11. J

    Raw water flow

    Curious on how much water I shoukd see coming out of my exhaust and prop while running on muffler. Ford 302...mc-1. I just changed the impeller and housing. Could someone post a vidio if possible
  12. J

    Mercruiser start issue

    Bad ground to solinoid...thanks fellas all good now
  13. J

    Mercruiser start issue

    Right it was just dead...I will get meter out...just seems very random
  14. J

    Mercruiser start issue

    It started fine....then I shut it off...aboutb15 min then went to restart...and that's all I got...
  15. J

    Mercruiser start issue

    I've changed starter solinoid and the main breaker
  16. J

    Mercruiser start issue

    I have an issue with start...all of a sudden it wouldn't start and when I turn key to start the oil pressure and temp gage pin full...no dashlights...everything else works
  17. J

    Electrical issues

    It is a ford 302 if that makes a difference
  18. J

    Electrical issues

    I have developed an issue that has fried 2 starter soliniods...first time it was no start and the gouges jumped to full on...and same again...what could cause this
  19. J

    Heat exchanger leak

    I am changing it. Thank you
  20. J

    Heat exchanger leak

    Is that correct orientation..top curled to the right?
Top