Search results

  1. alldodge

    Trim Tilt 3 toggle control wiring.

    Look at your wiring diagram top left corner at the trim limit switch. If limit switch is not adjusted right or is not working, only the trailer up switches will work
  2. alldodge

    8.1 GXI-J Cranks but No Start w/ Diacom Logs

    Could be, I always like to put a little oil or grease before installing on O ring
  3. alldodge

    Bayliner Capri 2150 resurrection.

    Nice work good craftsmanship
  4. alldodge

    Sitting in a hotel room when I don't wanna... Hurricane Idalia

    Ya left out the boy-howdy
  5. alldodge

    Sitting in a hotel room when I don't wanna... Hurricane Idalia

    Weather said it was going to rain hard around 11 today and was sprinkling when we left the house at 830, so we took rain coats. At 11 it was high and dry and stopped sprinkling after we got to our destination. Just the way it goes
  6. alldodge

    Antifreeze Question

    Another oil thread type My 1994 Rinker 454 and 1995 Formula 502 raw water cooled and "never" had any AF added. Both boats are still running (get messages now and then from owners) and no issues Oh Edit: other views are coming, hold tight
  7. alldodge

    Sitting in a hotel room when I don't wanna... Hurricane Idalia

    So your the one who made it turn ;) Ya know if you didn't leave it would have hit you square Wife's Aunt is still not back in her house after the last one
  8. alldodge

    8.1 GXI-J Cranks but No Start w/ Diacom Logs

    Being open cooling, the cooling issue may very well be caused by crud caught in the thermostat. The thermostat should keep the stat closed for the most part but higher rpm moves to much water thru so motor gets cool With it being touch and go with start/no start if it was mine I would replace...
  9. alldodge

    4.3 Mercruiser fuel supply issue

    The cover snaps on in the middle top and bottom Need to press inward
  10. alldodge

    4.3 Mercruiser fuel supply issue

    With the pressure being low (should be 43 psi) it's either the pump, regulator or a restriction. If it never gets above 30 even at idle with primer bulb, then either pump or regulator but most likely the pump The pump is a pain to get at as you can see. The regulator is on top the cool fuel...
  11. alldodge

    4.3 Mercruiser fuel supply issue

    ok, the cover just pops off The SN came up as invalid so I change the last digit and it came back as 4.5 Sorry couldn't help
  12. alldodge

    4.3 Mercruiser fuel supply issue

    The Pic looks like oil lines to a cooler. Have not worked on a 4.5 but the pump is connect directly to the fuel tank line. Think it's on the starboard side Check the fuel tank vent line next time it dies. Open gas cap and listen for air sucking in.
  13. alldodge

    4.3 Mercruiser fuel supply issue

    Thanks the S/N shows Mercs new 4.5 Pressure should be 43.5 within 3 seconds of key turning ON Should be 37.7 psi at idle I would install gauge and leave it when running https://www.crowleymarine.com/d/tech_article/specifications-power-unit-technical-data-2017-lit-18616-03-35
  14. alldodge

    4.3 Mercruiser fuel supply issue

    How about a serial number? Mentioned about 30 at the rail so it should be MPI but if that's the case it most likely should be 43
  15. alldodge

    Solas stainless 4 blades all the same?

    See if you can find a prop repair shop, many will swap props once you buy one Another option is contact Hill Marine and they will advise and swap new prop with until you get what you want
  16. alldodge

    Solas stainless 4 blades all the same?

    IMO, yes The 4B has more bite
  17. alldodge

    Bayliner Capri 2150 resurrection.

    Nice looking one
  18. alldodge

    Rear view Mirror

    Just thought of something but is more complex Look for a car for the Admiral and looked at one with a rear view mirror which is also a camera. So if you have things in the back that obscures the view, flip the switch and mirror is now a camera with same view. Begs the question why have a...
  19. alldodge

    Rear view Mirror

    Thanks I do want convex so it covers more area, but as before it's just the blind spot thing
  20. alldodge

    No power at coil: Volvo Penta 3.0

    With a carb it should be pretty simple Does your distributor cap look like this one? https://www.amazon.com/Distributor-Ignition-Replacement-MerCruiser-Engines/dp/B08HYDXD5B Need a voltmeter and follow voltages Wiring goes from key on purple wire to kill switch From kill switch to pin 5 on the...
Top