Search results

  1. alldodge

    Limp mode

    ok no codes Some codes don't set, some re only active when running, would need scanner for that
  2. alldodge

    2006 Mercury Verado 200, possible pencil coil issue?

    Unable to provide some good info, but if motor does have a miss the ECM will store a code. Need to scan motor for sodes
  3. alldodge

    When does anode require replacement?

    Both are correct Anodes should be replaced when around 25 to 30 % are gone
  4. alldodge

    VP 4.3GS Fuel Delivery Problem?

    Contact Mike's and he will get you the correct one https://www.carburetor-parts.com/
  5. alldodge

    Charger for on trailer or shore power

    No difference, choose one that meets the needs and amount of banks. If both Bats come in full charged then only need 2 bank maintenance type, maybe 10 Amp. If one Bat is low, maybe trolling , then maybe 20 to 30 Amp 2 bank. Just search on web for what is needed
  6. alldodge

    Charger for on trailer or shore power

    Once a Bat goes to low it's usually damaged and needs to be replaced. If it won't charge back up then it's gone With Bat switch off there should be no draw, if you have some then might be the ALT. Doesn't make any difference for a shore power charger, trailer or floating. If you plug in...
  7. alldodge

    VP 4.3GS Fuel Delivery Problem?

    Borrow from local auto parts store https://www.harborfreight.com/fuel-pump-and-vacuum-tester-62637.html
  8. alldodge

    2014 4.3 liter TKS bogs after running 35 knots for 45 minutes.

    Seafoam your boat u decide. If it's drawing a vacuum and u hear air then after air is sucked in it will run fine until it draws another vacuum
  9. alldodge

    2014 4.3 liter TKS bogs after running 35 knots for 45 minutes.

    Fuel issue Open the gas cap and listen for air being suck in. If you hear air then your drawing a vacuum in the vent because the vent is clogged If not hearing air, check to see if you get a squirt of gas when throttle moves. Might also be fuel pump is weak, antisiphon valve on the tank is...
  10. alldodge

    Bravo One U-Bolt

    It is safety Bondo said ". It should be replaced 1st" If it wallow's out it could even crack and then steering is gone. Imagine running and the steering breaks
  11. alldodge

    Limp mode

    Would need to check for codes. Can check by using a digital multimeter with a tone built in, or a 12V resistor LED Put meter or LED across pins E and F of the DLC connector (on top motor near ECM with a cap on it). Put paper clip or other wire across A and B. Turn key ON (do not start) and...
  12. alldodge

    Limp mode

    It's on top of the motor and looks like the middle one. Look on the back side for a part number
  13. alldodge

    Limp mode

    If your ECM is a MEFI-4 then there is a power reduction mode that does not let rpm's go above 2500. MEFI-3 does not I'm seeing part numbers but I'm unable to determine if it's a MEFI 3 or 4 3858863 3801310 Replaced by 3860614 7749063 21242085 21242092 21242089 3832370 948211
  14. alldodge

    Volvo Penta 5.0 gxi intermittent starting issues

    What rpm's do you see when cranking?
  15. alldodge

    Volvo Penta 5.0 gxi intermittent starting issues

    If these where good then the motor would start, something is not present. Most likely it's an electrical issue, loosing spark or injector firing. You have a Flat distributor cap, has it been replaced? When cranking do the fuel pumps run? Is there 12V on the pink wire of the coil?
  16. alldodge

    VP 4.3GS Fuel Delivery Problem?

    Putting good gas in bad gas just makes more bad gas. Doing 1/2 tank replacement a couple times will make the gas not so bad and enough should be fine Pressure going from 4 psi to zero after replacing gas filter is weird, maybe the gauge. Spec list 4.9 to 8.5 psi at idle. Have you checked the...
  17. alldodge

    1989 Supra TS6M 5.8 overheating exhaust

    Hows the circulating water pump vanes?
  18. alldodge

    Shore Power Only?

    Agree most likely a Bat charger The AC and Fridge are 120VAC only so they won't run of Bats. You could replace Fridge with a AC/DC type
  19. alldodge

    Limp mode

    The motor is a 5.0 what (Gsi, Gi, other)? Did the motor ever run ok? How is the compression? What is timing set at, and does it advance as rpm increases? What is the fuel pressure?
  20. alldodge

    Volvo Penta 3.0GS Restrictor Plate position on Riser

    There different because someone messed up, don't know if it's the manual or the parts list. I would probably go with the manual unless the manual has been revised (newer date). My opinion VP want's to make sure its not installed top/bottom and can be placed in either position (inside or outside)
View older results
Top