Search results

  1. alldodge

    is my CDI supposed to do this? 2001 4 stroke 90hp mercury

    Don't know but comment on your testing Using a ohm meter to check the box without knowing the circuity inside would be a waste of time. Putting leads on one way and then swapping to the other is what's called a diode check. The issue is this only works for diodes and a transistor if your...
  2. alldodge

    Engine coupler alingment issue.

    The coupler should not move at all, should be rock solid
  3. alldodge

    Videos as attachments?

    You Tube, Imager, other sites
  4. alldodge

    Limp mode

    Yes, same way and while your at it check base timing
  5. alldodge

    Limp mode

    Ears are fine, point light at balancer and increase rpm. See how much it does
  6. alldodge

    Limp mode

    MEFI 3 no power reduction Need fuel pressure reading Would also be good to know if the timing is advancing as rpm's increase, need timing light
  7. alldodge

    Limp mode

    MAP sensor will not put motor in limp mode BTW when you set the timing did you jump pins A and B to put it in base timing mode?
  8. alldodge

    Alpha 1 Gen2 Trim drops when under power

    Yes problem is inside the pump, check valve most probable cause, but could be the shuttle valve
  9. alldodge

    Videos as attachments?

    You cannot send a vid but can link the vid to your comments/postings
  10. alldodge

    Canvas snap for windshield

    Top of my windshield is 1.5 wide by .75 thick. Have not found a snap that goes on one this wide, most is .75 wide. Anyone know where where to find a wider one?
  11. alldodge

    Issue with Blue Sea's Add-A-Battery Kit (new install)?

    Most likely the house Bat will need replacing. Put on charger for a several hours, then disconnect charger and let it sit for a few hours. Measure it, if its low then it needs replaced
  12. alldodge

    Breakfast Dishes and Biscuits

    Best kind of arrangement
  13. alldodge

    Breakfast Dishes and Biscuits

    And now me to, tell her thanks much Hope to do better
  14. alldodge

    2017 Mercury 150 EFI Bogging Down

    Fuel restriction, air leak in fuel line or weak pump
  15. alldodge

    better to be at the low end or top end of RPM?

    I always shoot for the high side, motor works easier getting there and hardly ever go full WOT
  16. alldodge

    Exhaust Manifold and Riser - HOT

    It's normal idling or on a hose, pump just isn't moving enough water. The difference between pretty warm and hot is just a few degrees to the touch. One side will always be hotter then the other also, just the way the motor works
  17. alldodge

    Breakfast Dishes and Biscuits

    Just found my answer, convection is faster but that's not good for baking. Hope my hockey puck days are over
  18. alldodge

    Breakfast Dishes and Biscuits

    Wonder if it has anything to do with a convection oven instead of regular oven?
  19. alldodge

    2006 Mercury Verado 200, possible pencil coil issue?

    It's pricey but might want to invest in a scanner from Rinda. Cheapest is the Techmate Pro
  20. alldodge

    Breakfast Dishes and Biscuits

    I'll give it a try but it's real close to several recipes tried before. I do all these things and still wind up with barely risen hokey pucks
Top