Search results

  1. alldodge

    1997 3.0XL carb rebuild kit

    Best way to know what kit is with a serial number Next best is contact Mikes's carb. He will fix you up right and if its not right when you get it he will make it right https://www.carburetor-parts.com/
  2. alldodge

    Mercruiser 5.0 50 degrees at idle

    Balancer may have slipped To verify may need a piston stop bolt
  3. alldodge

    Mercruiser 3.0l TKS stalling

    Those are the venture's and a little drip is no issue. From your symptoms your most likely getting to much fuel so its flooding a little. This can be from a piece of crud getting in the carb needle seat, or just need to re-adjust things. The enrichment module is not the overall cause, because...
  4. alldodge

    Mercruiser 3.0l TKS stalling

    Yes, but most likely there is carb problems
  5. alldodge

    Mercruiser 3.0l TKS stalling

    No not normal, might need cleaned but may need replaced. Remove it and check measurements cold and warmed up
  6. alldodge

    Trailer bearings wear out ultra quickly.

    Check this one out https://www.boattrailerparts.com/Galvanized-Boat-Trailer-Axle-95-inch-3500lb-Square-by-Dexter_p_855.html
  7. alldodge

    Brand New Boat Owner!

    The outboard key has a feature that when pushed in a solenoid is energized on the motor that chokes the carb. As long as it is pushed in the choke stays closed Wiring for the key
  8. alldodge

    5.0 mpi backfiring through exhaust. Won’t start

    The cap should have the ports numbered, and left bank on left (1-3-5-7)and right on right (2-4-6-8). Makes it easier then the round ones Key ON pump should run for 2 seconds. Use a rag and push in on the schrader valve on fuel rail and see if fuel squirts out. If no gas, turn key ON/OFF a...
  9. alldodge

    5.0 mpi backfiring through exhaust. Won’t start

    No they are different. Boost pump is a low pressure pump at the fuel filter, and high pressure is under the motor port side
  10. alldodge

    5.0 mpi backfiring through exhaust. Won’t start

    Woops ok you have the additional boost pump
  11. alldodge

    Analog to Digital

    Being a 1990 I don't think the motor would be compatible unless its been replaced with a newer model. But if there is @dingbat might know
  12. alldodge

    5.0 mpi backfiring through exhaust. Won’t start

    My guess is the PO knows something he's not saying, and the Bravo does rotate in either direction What's your serial number?
  13. alldodge

    2014 3.0 mpi want go over 2500 rpm’s we have Cleaned all injectors replaced distributor and idles fine just will not go over 2500 like it’s on a rev.

    yes Disconnect the in-gear switch and see if it stops
  14. alldodge

    FLYWHEEL HELP!!!

    Looked up both I/O and IB 5.7 for 1996. There are different flywheels, and they both weight 33 LBs. The bell housing does show the IB starter comes in from the rear, all parts can be obtained today If you look at the side views of the 2 it sure looks to me like the ring gear is just on the...
  15. alldodge

    FLYWHEEL HELP!!!

    You built a 1996 motor and I know the 96 flywheel doesn't use a groove
  16. alldodge

    FLYWHEEL HELP!!!

    You sure about that? All other rings are installed by getting the flywheel cold and the ring hot. They don't move after that, easy peezy Hey @Bondo or @Scott Danforth
  17. alldodge

    FLYWHEEL HELP!!!

    Why not remove and Replace the ring gear
  18. alldodge

    Leak from "Lower/upper shoe"??? HELP!

    Everything is easy for those that have done it a few times and have the necessary tools. A first timer needs to read up on what is needed to do the task. Pull the drive first and find out what is needed then we can provide more thoughts. To pull, move throttle handle full forward gear...
  19. alldodge

    Leak from "Lower/upper shoe"??? HELP!

    It isn't done anymore but back in the day Searay did it for the looks. It is a Merc Alpha 1 drive that has been painted with decals. There is a guy here with a real nice 21 ft Pachanga
  20. alldodge

    Solar Power Installation . . .

    Not to sure a dc/dc would work. Takes power to run and just how much is not specified. How much of the 100 watt (on a sunny day max) would be used to produce enough to charge the others. Understand its being powered from the single Bat that is being charged by solar panel, but anything above...
Top