Search results

  1. S

    Ready to call 911

    This video is a little better in my humble opinion....shows how to make the brush holder while you assemble. Saves the cost of buying one plus the other guy didn't explain or aline it properly. Cheers
  2. S

    Ready to call 911

    You use this button to post a picture. After pushing it, it takes you to pictures on your phone....scroll through them until you find the pic you want and then post it.
  3. S

    1976 6 hp Evinrude "slipping or over reving" coming up on throttle.

    More of a cap than a nut but whatever.
  4. S

    1976 6 hp Evinrude "slipping or over reving" coming up on throttle.

    I'm not aware of any "prop nut".... should be a shear pin and a cotter pin. I'm betting internal gear assembly issue or two old fat guys in an overloaded 14 ft boat shooting birds might have to do something with it! 😜 Might be time for a bigger motor.
  5. S

    1975 Johnson 25 HP Not Running

    Yes, so it's probably time to tell him how to lap the new flywheel and mount it correctly so it doesn't happen again to him.
  6. S

    1975 Johnson 25 HP Not Running

    Not sure anyone needs to answer that, common sense says "yes" Finding the problem often is much harder than fixing it so I think you shall be rewarded soon.
  7. S

    1975 Johnson 25 HP Not Running

    Post pictures of cracks....began to start but didn't have enough to start....enough what? Backfiring is typically timing so your on to something. Make sure your plug wires are on the right plug.
  8. S

    1975 Johnson 25 HP Not Running

    I assume you tried screwing it out more correct?
  9. S

    1975 Johnson 25 HP Not Running

    I see.....I re-read the thread and it said you cleaned the carb, try rebuilding the carb. You might not have cleared everything as well.
  10. S

    1975 Johnson 25 HP Not Running

    By the way Race, please explain how does one put in one half of a drop?!😆
  11. S

    1975 Johnson 25 HP Not Running

    You need to diagnose the fuel pump before diving into all of this. Put drips in the cylinder but use a small spray bottle of fuel (50 to 1 fuel) to keep it running (throat of the carb) and then start pumping the ball and see if it runs. It's either fuel pump, carb related (not cleaning it...
  12. S

    86 Johnson gt 200

    Yes, and bring a kicker motor.....you will need it!
  13. S

    2003 Johnson 90hp fuel pump

    Check out post 7 on this guy's question. https://www.thehulltruth.com/boating-forum/772141-much-oil-fuel-vro.html
  14. S

    2003 Johnson 90hp fuel pump

    Drain screw on the float bowl. If it's full of oil and no gas your half way to solving it.
  15. S

    86 Johnson gt 200

    Being told by who? Bogging down sounds more fuel related.
  16. S

    2003 Johnson 90hp fuel pump

    If I remember right there is a check valve that can go bad and your carbs flood with oil. The test was to remove the cap on the oil bottle when running and it should clear up... Been awhile since I worked on one but open up a float bowl and see if oil flows out (no gas) If that's the case...
  17. S

    Harness conversion

    Is this what your looking for?
  18. S

    1975 Johnson 25 HP Not Running

    After you get it running with gas in the cylinders, try pumping the primer ball on your fuel hose. If it runs than your fuel pump needs help.
  19. S

    94 28hp SPL Johnson

    If there is deteriorating foam under the cowling, replace or eliminate it.
  20. S

    bought a new to me project today. 35 hp, EVINRUDE electric start with controls HAS NO SPARK

    Pull the red plug apart back at the motor.
Top