Search results

  1. alldodge

    Mercruiser 3.0 No Spark issues

    If you were able to slide the alignment bar in and out with 2 fingers, your probably ok
  2. alldodge

    dead kittens

    Don't know but might think about installing a access port https://www.amazon.com/boat-access-port/s?k=boat+access+port
  3. alldodge

    Axle rating help.

    Boat weighs 900, trailer might be 300, your good
  4. alldodge

    Electric Cars or Trucks

    Have not seen those time time lines, at least not with my vehicles. Have not had a plastic piece crack or deteriorate, vinyl yes
  5. alldodge

    Electric Cars or Trucks

    Plastic is forever, right? The old days the saying was, on a real quite night you can hear a Chevy rust
  6. alldodge

    2008 115 hp mercury 4 stroke EFI bogging.

    Been looking at the parts break down for the motor and I'm unable to find the fuel test port. Normally its a Schrader valve which is under a cap, but seems its not there. https://www.mercruiserparts.com/75-efi-4-stroke-1b366823-thru-2b0949 The service manual is 8M0085380 and would list how to...
  7. alldodge

    Bravo air operated drain.

    You should be good to replace like the other one. Part number 862776A01
  8. alldodge

    Waste Tank Level Indicator - Options?

    The one in your link was similar to the one which came with my cruiser. Used 3 floats and once the top one tunes ON, it shuts the system down and not able to use until pumped out
  9. alldodge

    2001 Mercruiser 5.7 TBI Won't Keep Running

    If your fuel line connects at posted item 3, then look on the other side (item 1) and see if that is the plug To ring out or ohm out is to set the digital meter on ohm scale. Disconnect the connectors from sensor and ECM. Then connect the meter probe to each end of the contacts and see if you...
  10. alldodge

    Volvo Drive Issues

    Would be better in the VP section but @Scott Danforth should have the answer
  11. alldodge

    2008 115 hp mercury 4 stroke EFI bogging.

    What is the motor serial number Check your fuel pressure
  12. alldodge

    2001 Mercruiser 5.7 TBI Won't Keep Running

    Do the wires ring/ohm out? If you have a plug (item 3) it can be removed and pressure gauge attached https://www.mercruiserparts.com/bam/subassembly/31844/2704/110 Otherwise you would need something like the Merc fitting to put inline where the fuel line attaches to TB
  13. alldodge

    Mercruiser 3.0 No Spark issues

    Should be a non-issue. The tube is just an extension of the fuel line. Being loose around the outside is no issue so long as the tube is not leaking on the inside. If it was leaking then it would run out of gas
  14. alldodge

    Mercruiser 3.0 No Spark issues

    I'm not hearing anything of concern, but recorded sounds may not be that good
  15. alldodge

    upgrading the ignition in my 4.3 Mercruiser

    You have a TBV ignition module, it's just the older style which uses a different connector. Its no longer made and if it needs to be replaced then there is a kit to change over to new design. The pic below is showing the newer design but where the wires go is the same except the Tan/Blue is...
  16. alldodge

    Mercruiser 3.0 replaced fuel pump

    Using a portable tank is a good idea To verify its not the pump, remove it from the block and reconnect lines. Now pump the pump by hand to see if fuel pumps thru the lines Being a new pump, my guess is there is an issue with the rod to pump movement
  17. alldodge

    Mercruiser 3.0 No Spark issues

    Not a carb expert but what I would do is find out what jets are in it now. Then can compare with what should be there, and then can decide what to change
  18. alldodge

    Mercruiser 3.0 No Spark issues

    I would suggest making the carb run richer. Increase jet size or get a larger carb. A motor won't be destroyed if it runs rich and can be leaned out later A take off bog can be lack of fuel Don't run it hard, maybe keep it just enough to cruse and give it time and recheck plugs
  19. alldodge

    Mercruiser 3.0 No Spark issues

    Don't see a 1 BTDC mark but would agree your about 23 degrees advance Need more time on the plugs to determine if its actually lean. Correct if I'm wrong but the plugs have very few hours on them
  20. alldodge

    Bravo air operated drain.

    Above the starter on starboard side should be a Merc plate riveted on
View older results
Top