Search results

  1. alldodge

    Running Out of Fuel - Half Full

    If pump has trouble drawing fuel up it gets to the point it can't do it anymore. Like a pump can only lift so high, a weak one may have the same in reverse Another thought; being a 2 cycle, can you get it going again by squeezing the ball again? If not then its not the pump Wonder if the...
  2. alldodge

    Vapor Lock?

    Easy test for overheat problem is get a piece of clear hose, double barbed fitting and hose clamps from HW store. Disconnect hose going into the Tstate housing coming from the pump. With boat in the water look for bubbles.
  3. alldodge

    Peter backs boat down the ramp like a pro

    cutie
  4. alldodge

    Running Out of Fuel - Half Full

    My thought also, fuel pump getting weak or fuel line has a crack so your sucking some air
  5. alldodge

    Engine Heating Problems - Please Help!!

    Your sketch looks close to what is shown on pages 10 and 11 in the pdf. Water comes into the Tstat and with Tstat closed water goes to the exhaust. The circulation water pump tries to move more water into the block but with Tstat closed nothing moves. Think your Tstat will have a hole which...
  6. alldodge

    2021 Ram Oil and fuel filters

    Agree but no area to put it unless maybe near the rear axle
  7. alldodge

    2021 Ram Oil and fuel filters

    Changed oil and fuel filters for first time on my truck. The oil filter is in the same location as the 2008 (old truck) but they have some kind of protection steel piece of @#$ in the way. No way to get at it from under the truck so you have to get at it from the passenger side wheel well...
  8. alldodge

    Engine Heating Problems - Please Help!!

    Been looking around and found a 2013 5.7 and it doesn't have much info on the cooling, but does show hose routing http://www.nautiquespain.es/shop/img/cms/Monsoon%205%207%20411344E%20Combined%2001-07-2014.pdf Everything running cool to touch sounds normal with the water temps your in. The...
  9. alldodge

    Engine Heating Problems - Please Help!!

    IF the thermostat is working and shutting off cold water from coming in until it opens, the no
  10. alldodge

    Engine Heating Problems - Please Help!!

    Unsure if Indmar uses a analog temp sender and a digital temp sender for the ECM like Merc/VP. You mentioned verifying resistance values with chart (gauge checks) ones so I will assume it does. Use an IR temp gun and measure temp at the thermostat housing at the sender locations. This will...
  11. alldodge

    Power issues after new batteries installed

    Start from scratch Connect Bats, turn Bat switch on 1 or 2 Measure at starter post Measure at panel If either does not have power, measure at Bat switch, then at end of each cable until you find where power is lost.
  12. alldodge

    Power issues after new batteries installed

    The meter was on auto range so it read millionths 0.00019V which can get that from a floating ground. With Bats disconnected a meter will do that Now if your saying your getting actual volts with the Bats disconnected, then I'll ask does it have shore power connection, and is it turned on?
  13. alldodge

    mercurier 350 mpi missing at high rpm

    Which 350 mpi (serial number) At what rpm does it start to miss ?
  14. alldodge

    Power issues after new batteries installed

    The meter shows 19mV
  15. alldodge

    Power issues after new batteries installed

    Reading 24V at the panel means the Bats are wired in series, that's the only way you get 24V
  16. alldodge

    Power issues after new batteries installed

    It was working fine and now its not, so something was not put back together the same way. We cannot see how its wired without pics, and even then it will be hard to do. Look for a hot or ground not reconnected
  17. alldodge

    Mercruiser 3.0 No Spark issues

    The ports are shown in this link https://www.thehulltruth.com/boating-forum/601303-water-coming-weird-place-mercruiser-i-o.html The shift interruptor is only used when the prop has a load on it in the water. There is no load on the prop out of the water so its not used
  18. alldodge

    Mercruiser 3.0 No Spark issues

    Not pulling the drive apart then the 2 halves are not part of the problem The shifting issue is either the cable or the shift foot was bent when removed when not in neutral The exhaust relief ports are about 1/2 inch size holes on each side of the transom assembly between the trim hose...
  19. alldodge

    Mercruiser 3.0 No Spark issues

    There is exhaust relief ports there so it may not be an issue With gear shifting issues, might be an issue with not putting the upper and lower together correctly. With the shift foot rotated fully and hard so it winds up facing straight forward. Prop rotated so it locks CCW and then bungee...
  20. alldodge

    Johnson Ultima 1250gph Bilge Pump

    Bad connection somewhere. Could be float switch or its connections
Top