Search results

  1. alldodge

    03 Bayliner 185 with Merc 4.3, random beeping

    Most likely a bad connection somewhere Check grounds to ECM
  2. alldodge

    03 Bayliner 185 with Merc 4.3, random beeping

    Could be a loose connection or several other things, but until it stays ON it will be hard to find. Does anything happen other then the beep? This should be in the Merc section
  3. alldodge

    Electric Cars or Trucks

    Ahhh no The furthest would put everyone closer to 55mph, and there is a song about 55
  4. alldodge

    Bayliner Capri 2150 resurrection.

    To pre-oil a GM motor (OMC, VP, Merc), remove distributor and use a drill and flat screw driver end or similar and spin oil pump thru dizzy hole
  5. alldodge

    New member - deck install panga

    Looks great Grouper Not required so far as I know
  6. alldodge

    4.3L MPI 2007 Searay Sport 185. Single Alarm at 20 RPMs and higher

    No, they do not talk to ECM
  7. alldodge

    Trim Lifting Motor Very Slowly

    If this just started, its probably a pressure issue. Something inside the pump is not allowing the pressure to build correctly. Up should have more pressure then down
  8. alldodge

    Water in oil

    Intake gasket leak would be first guess Do a compression test to see if its a head
  9. alldodge

    4.3L MPI 2007 Searay Sport 185. Single Alarm at 20 RPMs and higher

    We need to know what is causing the alarm, and so far what we/you have available is not providing the info needed, so we continue to guess
  10. alldodge

    Email Notification Issue

    Yes has happened before, don't know why it started working again last time Checked and everything is on yes, but still not getting anything and nothing in spam folder
  11. alldodge

    Email Notification Issue

    S couple days ago I stopped getting email notifications. Figure it may clear up but not so far. I do see Alerts once on site of them Anyone else having the issue?
  12. alldodge

    Bayliner Capri 2150 resurrection.

    Never used them
  13. alldodge

    4.3L MPI 2007 Searay Sport 185. Single Alarm at 20 RPMs and higher

    No, just needs to tighten up Bummer, really need a scanner, otherwise were guessing. Your boat has 2 oil pressure senders, 1 for the gauge and one for the ECM and they do not talk to each other. The gauge can read ok, but the ECM might see low pressure. I'm still puzzled by the motor dying...
  14. alldodge

    4.3L MPI 2007 Searay Sport 185. Single Alarm at 20 RPMs and higher

    Retract this statement, many folks have tried and many have failed
  15. alldodge

    4.3L MPI 2007 Searay Sport 185. Single Alarm at 20 RPMs and higher

    Won't help much but mercruiserparts has it for 168 Walmart for 152 At 20 something for aftermarket, I might have to try it once
  16. alldodge

    4.3L MPI 2007 Searay Sport 185. Single Alarm at 20 RPMs and higher

    Not sure they will work. There is a thread here done some time back where a group of us tried to get info to find a replacement. Never did but did gather some info Its a 3 wire resistor type. Grn, 5V and sensor
  17. alldodge

    4.3L MPI 2007 Searay Sport 185. Single Alarm at 20 RPMs and higher

    And running the motor above 1600 can burn the impeller
  18. alldodge

    4.3L MPI 2007 Searay Sport 185. Single Alarm at 20 RPMs and higher

    The water switch is the number one failure on these motors. With it disconnected it tells the ECM there is zero pressure
  19. alldodge

    4.3L MPI 2007 Searay Sport 185. Single Alarm at 20 RPMs and higher

    In neutral of in gear? Wait your on a trailer and 2000 RPM, Ahhh the plot may be thickening Your motor has a water pressure switch on the power steering cooler. When the engine RPM's increase over 1800 the pressure must be high enough or the ECM will alarm and decrease RPM's to save the motor...
  20. alldodge

    4.3L MPI 2007 Searay Sport 185. Single Alarm at 20 RPMs and higher

    How did the switch check out?
Top