Search results

  1. Faztbullet

    Yam 85 Losing Power.-

    That motor does not have a limiter or safe mode. The temp sensor when it reaches about 190° turn on the overheat lamp.
  2. Faztbullet

    Kill Switch installation

    Wrong type kill switch....if you take a ohm meter the 2 posts should be open with tether on and closed with tether removed.
  3. Faztbullet

    Kill Switch installation

    If kill switch has 4 post swap them to other 2 ...switch has to be open to run and closed to stop.
  4. Faztbullet

    1986 90 hp Mercury inline 6

    Yep ..just toss Autoblend and install a hose splice where it was.
  5. Faztbullet

    Ignition coil

    Need to check ignition system as those coils rarely fail..
  6. Faztbullet

    Ignition coil

    Why do you think it needs replaced?
  7. Faztbullet

    Need a little help 150 evinrude intruder lower unit

    Have to pull pinion gear and driveshaft...why you wanting to remove if only seals?
  8. Faztbullet

    Ignition coil

    Motor should have points and 2 coils...
  9. Faztbullet

    513031 Timing Wheel Encoder

    Got a pic of bottom and timing slots?
  10. Faztbullet

    Need help Frankenstein

    If its a 30hp no matter the year answer is no.
  11. Faztbullet

    Jet unit

    No....
  12. Faztbullet

    2 stroke oil spilling from carburetors?

    Replace oil cap on oil tank as its not venting.
  13. Faztbullet

    Jet unit

    Most jets are on semi-flatbottom hulls, a jet on a deep V defeats shallow water operation. What are you trying to do?
  14. Faztbullet

    Prop size stamp?

    Need to pull it off anyway as incorrect prop washer.
  15. Faztbullet

    Can't be that simple

    Thats all...carbs and jet size.
  16. Faztbullet

    4 stroke merc 40 into 60Hp mod

    ECU is dumb...will not "relearn"
  17. Faztbullet

    Water in lower unit oil/ oil leaking

    Looks like your running a Shooter or other small hub prop. These have a tendency to hammer the bearing carrier at raised transom heights. Unit need torn down, bearings and bushings checked and carrier swapped over to the 2000+ year with wedge
  18. Faztbullet

    rejetting carbs on a 1990 60 hp Johnson for high altitudes

    Best to change prop...
  19. Faztbullet

    Height of jet foot compared to boat

    Thats a good all purpose setting. Unless the water you go into is really skinny I would leave it be.
  20. Faztbullet

    1998 Evinrude 35hp water temp issues!

    Put a impeller and t-stat assy in it.
Top