Search results

  1. Faztbullet

    Mercury Inboard taking on water and splashing on engine

    Picture? Sounds like a heat exchanger
  2. Faztbullet

    Flywheel Doesn't Line Up

    Check flywheel key...
  3. Faztbullet

    Epoxy type to use in water jacket

    Best to use aluminum Devcon epoxy.
  4. Faztbullet

    Miss marked prop?

    Need to go back to using your old screen name as it describes you and your thought processes to a tee......LOCO loco [ loh-koh ] noun, plural lo·cos. locoweed. Slang. an insane person; maniac. Slang. to cause to be insane or crazy. adjective Slang. out of one's mind; insane; crazy.
  5. Faztbullet

    Miss marked prop?

    What you posted is pure BS... The designs of propellers are done in labs and hydraulic testing and formulas ..Something that way above your intelligence level as anyone can see from some of your posts. The gaps between splash deflectors have no effect on motor. RIB will need to run deeper than...
  6. Faztbullet

    V4 CROSSFLOW HELP,REBUILD.

    Yes but it would be cheaper to sell it and by bigger motor. You have the old style 115 de-rated to 100 hp at prop. Max you can get is about 10-15 hp extra with a lot of work and $$$/ Cheaper to by a140hp looper..
  7. Faztbullet

    V4 CROSSFLOW HELP,REBUILD.

    Spray some carb clean is so called hole and watch where it comes out...then you will see purpose of hole. Someone has been dinking with motor before you so check pistons to see if installed correctly and if bored oversize. Do not try to re-ring motor is worn past its limits (.003) Boat is also...
  8. Faztbullet

    Service Manual

    1999-2005 60° manuals will work...that model was white
  9. Faztbullet

    2003 Johnson 140 4stroke 2-2 code help

    Here is what I found(CC) 2-2 air intake code: Since these motors have no air filter, the plenum, will collect crud as mine did. This can clog the MAP sensor (small black sensor on the top rear left of the air intake plenum). It can also clog the throttle body butterfly and prevent proper closure...
  10. Faztbullet

    No Oil Alarm Occurrences on Rebuilt 1986 Johnson 150 J150TXCDC

    Check the float in oil tank and screen. If ok replace the pump as cannot rebuild oil side. The side you repaired is fuel and air motor and if o-ring was problem you would have fuel delivery problems. Only use OEM pump and not knockoff chinezem brand.
  11. Faztbullet

    Mercury 150 Black Max ~1992 year model

    I got caught some good fish down at Big Spring Creek🐟🐟
  12. Faztbullet

    Oil Alarm going off with '98 Yamaha ProV150 two stroke

    Oil pump is not monitored only oil levels. is oil light illuminated on guage?
  13. Faztbullet

    1989 Johnson 175 GT Rebuild Thread

    Yes the 89 should be the 2.6L bubble back, but someone could have swapped powerheads,,reason I asked. The 2.6 was thin walled and many bit the dust due to overheating.
  14. Faztbullet

    1989 Johnson 175 GT Rebuild Thread

    A VRO cannot cause certain cylinders to fail as the mixture out to carb is same for all cylinders. One of the biggest misunderstandings for VRO. Is it a flat back or bubbleback?
  15. Faztbullet

    1995 yamaha 60 tiller acceleration issue

    Rebuild carbs and replace all under cowl fuel lines
  16. Faztbullet

    2011 Yamaha f150txr intermittent fault

    Check the shift switch..
  17. Faztbullet

    Pulse Limiter

    It tis bad..either replace with newer OMS pump or standard fuel pump depending on engine type.
  18. Faztbullet

    Pontoon Dolphin fin or not??

    Not needed on a toon.....
  19. Faztbullet

    1985 Mercury 90hp in-line six compression

    Lil high for a 1985 but gauge could be off. usually around 115-125psi
  20. Faztbullet

    Powerhead interchangeability

    Pre 1991 2L 135/150 will fit. After 1991 they went to fat block casting like 2.5L. These will also fit but have to get whole assy as heads,exhaust plates different
Top