Search results

  1. alldodge

    L6 Mercruiser simplified engine wiring

    Just noticed you removed the purple on the ALT and added a wire to the bat What you have will work but will need to put the purple wire back to the ALT. In fact the ALT needs 4 wires total Orange - output to bat Purple - Excite which turns the ALT on from the key Red/purple - 12V full time...
  2. alldodge

    Bravo 2 outdrive not engaging when in gear

    What, no oil slick drive again :unsure: :ROFLMAO:
  3. alldodge

    L6 Mercruiser simplified engine wiring

    The wiring isn't correct in design nor color for AYBC The red from the run circuit is connected correctly, but uses a white resistance wire. This in it self is ok, but should be purple or go to a ballast resistor, unless a resistance wire is used There is no ALT output connection back to the +...
  4. alldodge

    Universal M25 Oil Pressure Switch

    Unless there is a gauge (don't think so) then guess its the man removal
  5. alldodge

    Carver 3007 1981 Engine sea cocks

    In most cases when discussing specific things on a boat which may be different, its best to post a pic In most cases the seacock is a ball type valve. This means the handle should be inline with the hose when Open and cross ways when Closed. They should always be open when running the motors...
  6. alldodge

    Universal M25 Oil Pressure Switch

    While most use a wrench, you can also use a socket. Have you tried a socket? Not real familure with the motor, but if it has a oil pressure gauge then the switch could be Tee'd with the sender
  7. alldodge

    Milky madness

    40 watt bulb will keep it plenty toasty If you really want to just keep it warm for the winter and there is no power outage just get the proper heater and go...
  8. alldodge

    Impeller for 5.0 GL PEFS

    Thanks Bruce, can you clarify the 1348 is impeller and O ring, where the 1346 is the O ring and 3 paper gaskets, right? https://www.amazon.com/Volvo-Penta-Impeller-21951346-3862281/dp/B00KQ8DBKC
  9. alldodge

    Bravo 2 outdrive not engaging when in gear

    Oh yes, forgot about that little thing But if that coupling is attached your not going to be able to turn the prop
  10. alldodge

    Bravo 2 outdrive not engaging when in gear

    All shifting is done in the top half, its just gears in the lower. Check to see if its in throttle only. Otherwise I would pull the rear cap off to see if the shift mech is moving when shifted
  11. alldodge

    Bravo 2 outdrive not engaging when in gear

    As the Bravo is installed the cable needs to be latched into the keeper before moving it the rest of the way into the bell housing. Grab the latch with pliers to pull it out if its inside. Latch cable and push in
  12. alldodge

    Impeller for 5.0 GL PEFS

    I'm finding kit number 21951346 Used this site to look it up https://www.volvopentashop.com/epc/en-US
  13. alldodge

    Impeller for 5.0 GL PEFS

    What is the motor serial number?
  14. alldodge

    L6 Mercruiser simplified engine wiring

    This is the helm wiring using the standard 10 pin harness Note all gauges tie into the Purple
  15. alldodge

    L6 Mercruiser simplified engine wiring

    The ALT should have 4 connections Ground - Black Output - Orange Sense - Red/purple from 50 amp breaker Excite - Purple from key This is a 3.0 using EST distributor but other then that the wiring will be the same
  16. alldodge

    2000 Yamaha GP1200R- Fuel/Air Issue?

    Not familiar with Yams, but they all operate about the same Blow the lines out with air but be careful with not to much air. Might be a screen in the tank or other. You have Mikuni carbs and pumps. The pump is a small rectangle mounted on the motor. It uses exhaust gases to work the pump...
  17. alldodge

    L6 Mercruiser simplified engine wiring

    If you go ABYC then use 3 pole key switch (Bat, Run, Start) In drawing above it shows Acc going to 2 gauges and the ALT. These should go to the run circuit even if you rewire with 4 pole key.
  18. alldodge

    Milky madness

    Take the garden hose and connect it to the thermostat and let it run full force for a bit, to check for a crack. The oil pan will start filling with water or you will see water pouring into the bilge if there is one
  19. alldodge

    2000 Yamaha GP1200R- Fuel/Air Issue?

    Maybe running out of fuel Fuel pump, filter, fuel line restriction
  20. alldodge

    Converting 5.0 mpi to closed cooling

    2011 and CATs, have always heard CATs came in during 2014
Top