Search results

  1. alldodge

    Thermostat Housing Check Balls

    haven't drained a V6 in a long time and when I do my BB there is always some water the comes out both sides, just not as much on the second side. I think your good, but to verify, put Port plug back in and then pour water into the thermostat housing and see if water comes out the starboard side
  2. alldodge

    Starter issues

    Remove the battery cable ends from the starter and the negative on the engine block. They should be clean and shinny, and bend the ends to see if there is any corrosion under the jacket. If all that is good, then agree with gm280
  3. alldodge

    Help with 5.7L front motor mount bracket location.

    Where did you find this Rick. The install manual list transom angles can be 10 to 16 degrees and that angle is used to determine X dimension. Where not talking X dimension here, but if the transom can be at a different angle, then so can the plate
  4. alldodge

    Column Replacement

    I'm supporting the roof with 2x10 at an angle so the contractor can pour the porch. I'm putting it back together after their done. Just looking for better ideas of how to reattach at the roof
  5. alldodge

    Help with 5.7L front motor mount bracket location.

    Your using 13* but is your stern at 13*? It could be anywhere from 10 to 16* The mounts wind up where they a parallel with the gimbal bearing and drive. Need to try and be in the middle of the motor mount adjustment
  6. alldodge

    Column Replacement

    Simple task, but looking for ideas of how to do it better Current: Wood deck/porch with two 4x4 post holding covered porch. There is plywood or wood siding surrounding post, then vinyl siding and aluminum trim covering all wood. Plan is to cut post off flush at the top New: Concrete porch...
  7. alldodge

    1996 Volvo Penta 7.4 will not stay running

    New pump Put a voltmeter on the pump hot side and see if you get 12V to it while cranking? Now see if 12V stays there once the key is released and motor is running? If both are true and it still dies its either fuel restriction or an electrical issue
  8. alldodge

    Fuel hose size ?

    Splinting hairs maybe
  9. alldodge

    Fuel hose size ?

    Small block chevy (5.0, 5.7, 4.3L) and big block chevy (7.4, 8.1, 8.2L)
  10. alldodge

    Cutting cable TV

    Might be worth it to get a VPN (extra 3 to 6 mth) and then fake out the location for a place like Atlanta, New York or other city to watch local channels
  11. alldodge

    Fuel hose size ?

    Most likely its 3/8 SBC and BBC all same
  12. alldodge

    engine

    Try a heat gun or hair dryer
  13. alldodge

    Cutting cable TV

    Wish locast was in my area :( Not even close like Nashville of Louisville
  14. alldodge

    Computer Help!!

    In that case its do over time, wipe and reinstall One of the programs is either not installing correctly or not compatible with the computer hardware or OS. Verify SW
  15. alldodge

    Computer Help!!

    Something is corrupt and its hung. Hold the power button until it turns off. Then turn it back on.
  16. alldodge

    5.7L 350 - 2003 - MAP/ MPI Horizon - Water Distribution Housing ISSUE

    Pretty sure the top cover is glued on and needs to be there, otherwise it leaks. It can be replaced by making a Tee fitting. Member @Bt Doctur has made them from copper fittings. If your going to stay at idle maybe tape it on https://www.mercruiserparts.com/bam/subassembly/31748/8093/250
  17. alldodge

    Looking for best 2 cycle motor

    Dry, just wanted to see if the block was cracked My plan is to use my 125 with digital igntion and no distributor
  18. alldodge

    Looking for best 2 cycle motor

    Ran compression test on the 140 and 3 cylinders are 110 psi and 1 is 105 Tried to do the 120 but no starter, so I'll pull one off the 105
Top