Search results

  1. alldodge

    wiring help

    Using Minnkota it shows a 60 amp
  2. alldodge

    wiring help

    Could use some more info of what you have to start with. Assuming you have an OB motor. If this is the case and having a 24V trolling motor, then just need another bat for t=starting
  3. alldodge

    Looking For An Alternate Way To Winterize 5.0EFI Bravo II

    They OEM fittings should be brass 1/4 NPT to the 1/2-13 Merc. The Y fitting with the knock sensor should also be 1/4 NPT with the above fitting attached. Now the cool fuel will not have this fitting on it The hose going to the cool fuel could also be cut and one of these installed
  4. alldodge

    new dash / control to engine harness needed for restoration

    Going to need a few more parts then program the smartcraft gauge Maybe we can get some input from Fun Times to assist also
  5. alldodge

    Blowing Fuses

    It is true if the diode shorts the motor will continue to run. In the drawing below, power comes from the 20 amp fuse to the Thermal switch, then TKS module. When the diode shorts power will also go to the fuel pump. The thermal switch will not cause the diode to short out, it is just a...
  6. alldodge

    VP 5.7 GSi PEFS - temp 160 at idle, 110 at speed

    There should always be water going to the risers, the thermostat restricts flow to the block until it reaches temp This is not yours and only look at the Stat and the top exhaust connections of how water flows. The left shows the Stat closed and only a small amount of water flows out of the...
  7. alldodge

    Twin Merc Inboard 3000 RPM WOT

    Both doing the same thing is the puzzler The antisiphon valve is a barbed fitting on the tank which has the rubber fuel line attached to it. Its a spring loaded check ball inside which closes off fuel from siphoning out if the is a leak
  8. alldodge

    Boat taking on water

    Being the drive boot does not have any water in it Might be a soft transom but could still be Upper steering pin, trim wires, shift boot, intake hose, transom seal If its the transom, you should be able to take a phillips screw driver and push hard into the transom and there will be movement or...
  9. alldodge

    Gas tank sending unit not working correctly

    Guess I'll just take your word for it, because I don't see how it would be electrical. Your sender bottom appears that the lower plate (Blue arrow) would move with the float going up/down. The gauge pin (yellow arrow) looks like it would cause the gauge to move. Your walmart link was for a...
  10. alldodge

    Correct Dual Battery Switch setup

    You can use an ACR so don't have to switch, but then you would also need to move accessories to bat 2. So long as the stereo, fish finder and others are not separated you will always need to move the bat switch to save the start bat
  11. alldodge

    2002 Mercruiser 4.3 v6 oil filter adapter

    You know when I saw your oil filter adapter I thought automotive and oil cooler lines. After looking deeper, the same thing you have was also used as part of the older remote oil filter adapter. The one which came on the motor (2002 model) was this one When looking at your fist adapter it...
  12. alldodge

    trim hoses bravo III and manifod

    Most the pics in the parts catalogs are not 100% accurate. The longer one goes furthest away from the transom
  13. alldodge

    Bravo 1 swap out to bravo 3

    Agree, and will add, B1, 2 or 3 can be installed on a Bravo upper. There are differences in the cases, so look for which ones your putting together. Also note the ratio
  14. alldodge

    Removing or Living With Single Point Merc Draining

    Yours is early enough that the standard 4 port thermostat would be used for multi drain. It shows a check valve after cool fuel but not sure it needs it, even though yours has one before the module. Your cool fuel doesn't have a drain like the early ones, so they have install a Tee (861505)...
  15. alldodge

    Removing or Living With Single Point Merc Draining

    Have never removed one, but should be easy enough, just need some hoses. Could use your serial number to verify my thoughts All the items in Green can be removed and plugged. The ones in Blue would be routed to a new thermostat housing except the hose coming up from the drain. The exhaust...
  16. alldodge

    02’ Volvo Penta 3.0L gsm-c Dash and fues wiring diagram

    Just found a 3.0 GS A/B/C
  17. alldodge

    02’ Volvo Penta 3.0L gsm-c Dash and fues wiring diagram

    Don't have a GSM but do have the GL model. Looking at the GSM parts it should be real close to the GL (EST distributor, carb, alternator). There may be some sensor differences but wiring colors should be the same. If relays do not match up I have some older ones for the GL
  18. alldodge

    Stern Ladder that Fits

    Agree, you can make some brackets Found this one at Aqua Stairs I like this one, just search pontoon ladder, about $250
  19. alldodge

    1999 Mercruiser 4.3 cool fuel pump pressure

    Thanks for the update and good to here your up and running Dead heading a fuel pump should not damage it, Merc even has a test procedure to test the pump by dead heading it to ensure it will reach at least 60 psi. The fuel line is removed from the TBI or MPI fuel rail for the test. Your motor...
  20. alldodge

    Alpha one transom plate gasket replacement?

    The trim lines go from inside to outside the boat, so they go thru the transom. There is more then one seal there depending on if you have a mercathode or not
Top