Search results

  1. flyingscott

    1989 3cyl 75 HP Evinrude - Running on One Cylinder? (Videos Included)

    The fact you can hold those 2 spark plug wires means you do not have spark on those 2. . Is there water intrusion? those motors are known for exhaust gasket leaks. Timer base connected and moving ? Get an open air spark checker. make sure spark jumps 7/16 "
  2. flyingscott

    Johnson TN28 no low-speed fuel

    i just put orings in instead of the leather seals
  3. flyingscott

    Ultrasonic cleaners?

    get the heater and simple green works well
  4. flyingscott

    mounting my Mercury force 125 for repair

    make sure you have the right parts because a 1986 125 is not a Merc Motor
  5. flyingscott

    Frankenstein engine build

    75 has different block and head. Same bore and stroke between the 2. I would build the 60 as its a better all around motor. are you sure that 75 has trim and not just a tilt?
  6. flyingscott

    Starting Delay 1986 Johnson 150 HP Crossflow V6

    Does the starter spin on the first try? Is the bendix Sticking down?
  7. flyingscott

    96 johnson. Link and sink

    Have you tried adjusting the cable? Should be a Trunion nut on it
  8. flyingscott

    1987 Johnson VRO70 Model # J70TLCUR Alarm staying on

    where did you get the new horn from? OMS pumps do not measure oil pressure. they only detect flow.
  9. flyingscott

    '04 Merc 25hp dead(ish) cylinder

    check your stator
  10. flyingscott

    '04 Merc 25hp dead(ish) cylinder

    right gaskets in the carb. how many magnets on the flywheel
  11. flyingscott

    '04 Merc 25hp dead(ish) cylinder

    Where did you get the switch box from?
  12. flyingscott

    '04 Merc 25hp dead(ish) cylinder

    Doesn't that have CDM modules?
  13. flyingscott

    '04 Merc 25hp dead(ish) cylinder

    Run with a timing light. You could have a bad CDM module or bad pick up under flywheel. Tests need to be done.
  14. flyingscott

    Rebuilt Water Pump Pee question

    Is the screen clean?
  15. flyingscott

    Customer advice

    The machine shop will tell you how far to overbore. then buy a WSM kit and go boating
Top