Search results

  1. nola mike

    Replacement Fuel Sender?

    Exactly. Gauge doesn't even flutter. I'd be happy with a base 3 readout...
  2. nola mike

    Cobra sx outdrive

    If it's the Y-pipe you'll get water in the boat when running on muffs. If it's the transom seal/bellows/trim wire it will only leak in the water.
  3. nola mike

    Replacement Fuel Sender?

    The problem is that even at 1/2 tank, the area where the sender is located (aft section of the tank) is completely full. The tank empties as much fore-->aft as it does top-->bottom, since it's always angled towards the stern.
  4. nola mike

    Replacement Fuel Sender?

    Trying to get a somewhat accurate fuel gauge reading (like to within 1/4 tank would be great). I replaced it years ago and for some reason shortened the arm. I installed a heavier motor and cleaned up the helm connections. The heavier motor especially now shifts the gas to the stern, and the...
  5. nola mike

    starter fuse?

    Or an hour or 2 in some salt.
  6. nola mike

    Need help to identify 5.7l v8 engine

    200 (2 BBL.) GM 305 V-8 1987 - 0B525982 THRU 0B774444
  7. nola mike

    Boat swamped, let's see if we can get it running...

    OK, got my fancy pants timing light today. Much easier to set digital than the tiny knob on the other one. Set to 8', verified 23' advance at 2500 rpm. It was bouncing though; not sure if this is normal? A couple of degrees in either direction, only at speed. Steady at idle. Thought it might be...
  8. nola mike

    Boat swamped, let's see if we can get it running...

    No I didn't. Didn't plan on pulling them...They're on their second season. But good thought.
  9. nola mike

    Perfectly for 15 minutes then, surging, knocking, and jumping tac

    You can swap wires and see if the problem follows the wire. Carb rebuild is pretty easy. Even if you've never done it, shouldn't take more than a couple of hours.
  10. nola mike

    Perfectly for 15 minutes then, surging, knocking, and jumping tac

    Don't think op disconnected the tach
  11. nola mike

    Perfectly for 15 minutes then, surging, knocking, and jumping tac

    Like I said, agree that the immediate issue isn't the flashes (though it may mean the engine isn't performing as well as it could). But how do you explain the tach?
  12. nola mike

    Perfectly for 15 minutes then, surging, knocking, and jumping tac

    ? Intermittent flashes mean intermittent spark. Definitely a problem. See if you can tell if you're erratic with the light on the coil wire. If not, your problem is with the cap/rotor/wires. If so you have another problem. Agree though that if the flashing is the same regardless of symptoms then...
  13. nola mike

    Boat swamped, let's see if we can get it running...

    So I rechecked the timing, and it seemed that every time I set it, it was off again when I rechecked it. It was 40' advanced at 1 point, then I couldn't find where it was when I was trying to check advance at 2k rpm... So thought I got it, went out with 2 adults, 3 kids. Seemed sluggish out of...
  14. nola mike

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    1. Have you tried disconnecting all batteries except engine batteries? 2. Have you been able to get screenshots of the voltages when the fault isn't present? 3. Was this problem there on the sea trial or did it show up after you got the boat?
  15. nola mike

    Hard starts after sitting for a week or so

    I thinklutely! It was sitting in the driveway for a week. I think spec is ⅛"or so. But whatever works best for you. Mine doesn't need much if any choke in the 90' weather that I'm usually in, so I dial in a bit more so that it will open fully earlier
  16. nola mike

    Crank, no spark. Need advice.

    Didn't sound like that's where the troubleshooting led... You never got a spark by tapping the wire or from that last post you don't perform the test correctly.
  17. nola mike

    2016 Mercruiser 6.2 ECT - long beep every few minutes???

    Also noticed that on the engine data ignition voltage is > battery voltage?
  18. nola mike

    Oil Pressure Switch for Fuel Pump - Strange Happenings

    Op switch shouldn't affect cranking. Try wiggling the throttle while you crank (possible neutral safety switch). Next measure voltage at the small yellow/red wire on the starter solenoid while trying to crank... Rather than reinvent the wheel, go through this guide...
  19. nola mike

    Shift interrupter switch.

    There are a ton of module part numbers that I found, though don't see them broken down by outdrive. Same with wiring diagrams. Which ones are you looking at? And green still shouldn't be grounded, should be the same just without the SIS leg, only from module to distributor.
  20. nola mike

    Perfectly for 15 minutes then, surging, knocking, and jumping tac

    And 7
Top