Search results

  1. nola mike

    Outdrive Popping

    How/why did the engine get swapped without removing the drive? First thought is u joints. See if it makes noise on muffs, then pull the drive
  2. nola mike

    1999 Tige v21 inboard mercruiser engine (acts fueled starved under load)

    Why would any mechanic swap out the pump twice and the fuel gauge before draining the fuel, filters and going through the carb on a boat that sat 4 years?
  3. nola mike

    Engine no power under load

    Do we know what carb we're talking about? Is op talking about the secondaries?
  4. nola mike

    Swap a complete 1988 OMC 4.3 out and put a complete 5.7 Mercruiser I/0 complete with wiring harness in??

    V8 seems a bit of overkill in a toon, no?
  5. nola mike

    Swap a complete 1988 OMC 4.3 out and put a complete 5.7 Mercruiser I/0 complete with wiring harness in??

    Same width, you'll need some extra room up front. Motor mount locations are different. Cut out is the same. You'll need a *complete* engine package, controls, wiring, exhaust, etc.
  6. nola mike

    crawdad

    You need a 3
  7. nola mike

    Bayliner 305/350 swap

  8. nola mike

    Ford 302 alternator proper amp size

    A 1 wire can likely be used as well, though don't know your wiring specifics. @Scott Danforth , I assume the older wiring has all the helm power through the ammeter, which can't handle the increased current? I don't have a schematic...
  9. nola mike

    Trying to reprop, but how can I tell if my engine gets to WOT?

    Also, swapping the drive shouldn't have affected your throttle at all.
  10. nola mike

    '09 5.0 TKS (Carb) not running

    We were getting close! That goofy ass tks system strikes again... Thanks for the update, enjoy being on the water.
  11. nola mike

    Mercruiser Manual has a error in torque V6 Vortec

    Yeah, found that out after I snapped a bolt. We discussed it, starting post #153... https://forums.iboats.com/threads/nola-mikes-3-7-470-4-3l-swap-thread.720479/post-5463176
  12. nola mike

    Winterize

    Um, maybe what engine?
  13. nola mike

    Pic of Milkshake spew all over my engine. Help please

    This would be fascinating if this is what happens. @Lou C has been trying to convince me of the necessity of pulling this plug (which Merc doesn't seem to think is important). I don't buy it. I also fail to see how pulling a plug at the front of the intake will prevent water from pooling in the...
  14. nola mike

    Winterize

    Disagree. People pay for the service. Most people have zero clue about how their (fill in the blank) operates, and pay for the convenience of ignorance. If you pay for winterization/summerization ( which is a stupid amount of money IMO for the amount of work involved), you expect it to be...
  15. nola mike

    7.4mpi just started running rough and with gas coming out exhaust

    Where? I don't see a common wire that would only affect 1 side. Edit: unless splice 110 and 111 are physically close to each other, and you have all 4 of the affected wires right next to each other and chaffed
  16. nola mike

    7.4mpi just started running rough and with gas coming out exhaust

    This still doesn't make sense if the injectors aren't on an even/odd circuit. Please keep us updated.
  17. nola mike

    1987 Power Play XLT-185 - floors, stringers, and upholstery

    Awesome with your daughter. At a party last night ... Wife knew of a carburator, but didn't know what it was. Nobody else had even heard of it (seriously, hadn't heard the word). My kids knew it was "for measuring the gas". FTW.
  18. nola mike

    160 to 165 Mercruiser manifolds and backfiring

    Holy crap, mega-squirt. Buddy did this on vw's... That took dedication.
  19. nola mike

    3.0 Mercruiser Choking

    Certainly possible, but I'd expect it to surface earlier. Have you checked your fuel filter for gunk/water? Also, you can put a timing light on the plug wires to see if you're getting a consistent spark when this happens.
  20. nola mike

    7.4mpi just started running rough and with gas coming out exhaust

    Certainly sounds like a mechanical issue if 2 injectors from each side are fired separately from the other 2. But the voltage thing doesn't make sense then That might be helpful
Top