Search results

  1. stresspoint

    Embarrassing question

    adding a double dose is not the answer , add what is required to the amount of fuel you are putting in , 50;1 or there about . 100: 1 is border line for hit or miss as far as engine damage , those V4s are a robust little sod , guessing if you did not do high RPM running your motor will be a...
  2. stresspoint

    How to reposition lift rams

    you can just power up the trim system
  3. stresspoint

    Embarrassing question

    you may have broken the power band if you ran it with no oil . seriously: add 20 ml of oil to every liter of fuel ,i don't know gallons and ounces off hand but the mix above equates to around 50:1, that is safe for most 2 strokes requiring pre mixed fuel. FWIW , that motor will run fine @ 60 or...
  4. stresspoint

    How to reposition lift rams

    hook 1 ram up and extend or retract till they are the same length.
  5. stresspoint

    61 Sea King 40 hp need head gasket

    if you cant buy a gasket you can always have a copper one made . its an expensive option but in a no in situation its what i do when a OEM gasket is not available anymore.
  6. stresspoint

    Alpha 1 gen 1 refresh

    sounds about right to me, however, depending on labor charges in your area count on about 8 - 10 hours work +parts and shop supplies. there are a few things you could easily do yourself to save a few $$$ there is a saying about watercraft " use it or loose it " , which means if you don't use...
  7. stresspoint

    Starter won’t engage flywheel

    check the battery and terminals.
  8. stresspoint

    and you thought your day was rough

    you think ? :)
  9. stresspoint

    Outdrive Wont Go Up

    does the leg go up using the "trailering button "?.
  10. stresspoint

    Idle rpm 3.0 chev

    don't worry about setting the idle on the muffs only do this to get a base idle. on any motor the corrected idle speed should always be set with the motor @ full operating temperature , preferably after a good WOT run or a good run @ cruise speed if WOT is not practical. FWIW , i always do air...
  11. stresspoint

    Mercruiser 4.3 oil gauge mystery

    ha ha, funny you should say that , i was a culprit of doing that :) , FWIW. i did verified that the sender was properly grounded.
  12. stresspoint

    Mercruiser 4.3 oil gauge mystery

    i think that is where the problem possibly could have came from. something gone wrong inside the sender like diaphragm stuck or gummed with crap. guessing the oil pressure sender was OEM to the boat when new , so that would make that sender 30 years old, also it had been through a lot of...
  13. stresspoint

    Mercruiser 4.3 oil gauge mystery

    the first set of tests i did were rushed through, all seemed to be reading good enough for the gauge to work. the thing that threw me out was the fact that @ 2500 on the muffs i was getting a gauge movement , not accurate but a movement , in retrospect that would imply the system was working IE...
  14. stresspoint

    Mercruiser 4.3 oil gauge mystery

    not just others here , it tricked me as well , so don't feel too bad .(y)
  15. stresspoint

    Mercruiser 4.3 oil gauge mystery

    i tested as per posts on the internet to test a switch type sender that show to connect ohm meter to - to the screw in thread and the + to the gauge wire post , according to my research and practice it works the same with a sender unit except its a variable reading , not just on / off. as with...
  16. stresspoint

    Mercruiser 4.3 oil gauge mystery

    ok , so i could not wait till the weekend " you guys know how it is :)" went out and started testing and investigating ,"""" result was a bad sender unit """". earlier on i tested the spare know working sender unit against the one that was later proven to be faulty and they both tested...
  17. stresspoint

    Mercruiser 4.3 oil gauge mystery

    hey Scott , iv been searching to find a cheap capillary gauge with lines and fittings here in Perth Western Australia and i cant seem to find one under100 bucks , looks like i will have to order one online and wait , that's not going to help now , but having it there in the future will be an asset .
  18. stresspoint

    Mercruiser 4.3 oil gauge mystery

    yes Lou , i do have the wiring diagrams , in the manual , i also have the wiring diagram for the boat as well. i already put meter on that wire and its reading around 12.5 motor off and a tad more motor running @ idle. ground and sender wire also checked out fine. as posted , what seems to be...
  19. stresspoint

    Please help, no spark and so lost

    check the wiring on the new power pack , i had one that was wired wrong from the manufacture. i see your frustration , but just because these motors are small and look relatively simple , they are not , in fact they can be more complicated than a V4 or a V6 when chasing down faults. have you...
  20. stresspoint

    Mercruiser 4.3 oil gauge mystery

    how's it going Lou ? ,thanks for chiming in . my 4.3 motor is working well and keeping in line with your advice i am looking after it and have not managed to break it yet , i probably put 35 to 40 hours on it under all sorts of conditions this summer :), baring a few minor hiccups it did not...
Top