Search results

  1. C

    1968-1972

    this is for a bigger engine but the basic shifting should be very similar power is sent to the shifting coils via the top right shift selector which applies 12v to the appropriate wires feeding the shifting coils blue or green power comes the the A switch terminal on purple and is...
  2. C

    I have a 9.5 sport twin 1972

    Brown pudding may be due to old and sometimes wrong grear oil .. you could try a qwick refill and run the engine a while and recheck the oil. if you see no signs of coffee cream color you may be ok . you can alsways dump the oil again and refill. openning up these gear cases...
  3. C

    Johnson QD 17 water pump

    from a qd16 parts diag bummer :-( but now you can take the chance to replace any seals .. prop drive & shift while the GC is open change the spaghetti .... and find that retainer clip if somewhere in the GC weird ain't it ... did you pull out the drive shaft while doing pump work ...
  4. C

    Weak spark on Johnson 6hp -71

    yes caps go bad and mess up the ignition ...do them anyway if their age is unknown.. testing with a VOM is not conclusive anyway...they need to be load tested at 250 + volts for leakage. https://wrcoutboards.org/wp-content/uploads/2020/04/Part1_Condenser_Construction_Failure_Modes.pdf points...
  5. C

    Rkl-29e wont go forward

    from maxrule site looks like no power is reaching the FORWARD shift selenoid so check the green wire all the way to the shift selector switch but first check the connector (center of pic.) for poor or oxydized contacts https://maxrules.com/graphics/omc/wiring/67_68_40HP.jpg
  6. C

    1991 Evinrude 30HP - Oil Behind Starter Motor

    just for my info.. your carb seems different than the parts diag. for EV 30hp 1991 what is your eng. mdl # ??
  7. C

    Power/trim

    check utubes on fixing ptt ..likely worn seals
  8. C

    1955 evinrude 7.5 hp carb and starting

    no reason to leak if the proper gasket is used.
  9. C

    9.5 Ready for wet test

    to keep it from stumbling at a to low RPM speed and open up the idle adjustment 1/8 turn left to open it a bit more and feed it fuel .
  10. C

    '97 Evinrude 15hp Shifter adjustment(?) needed

    engine thinks it is in gear check shifter linkage for adjustment possibilities check lock out for adjustments ..
  11. C

    9.5 HP Sportwin 'Pops-Out-Of-Gear' and goes into neutral ...

    did anyone mess with the philipps head screw in the GC.... maybe the shift dog is loose in the GC ???
  12. C

    98 Johnson leaking hydraulic fluid.

    some T&T have a upper limit switch in series with the UP button circuit to the up relay the switch cuts power to the UP relay only when the engine is raised to high leaving only the DOWN switch to work till raisedagain to the uppeer limit ..picture not clear ... if it works don't...
  13. C

    9.5 HP Sportwin 'Pops-Out-Of-Gear' and goes into neutral ...

    if the GC at not at fault not much left.... side shift connector or.... adjusting the shifter handle on top
  14. C

    1990 Johnson 90HP 2 Stroke Bogging - Help!

    if carb floats are ok then the bulb should firm up. tried another fuel hose & primer ? external fuel leaks should be evident. any chance of a fuel pump diaphragm leak ?
  15. C

    1989 Evinrude 88SPL (E88MSLCER) Cooling

    wire brush the water jackets , soak cyl head in warm 30% vinigar & decrud several products can descale ...the innards ...see utubes
  16. C

    1955 evinrude 7.5 hp carb and starting

    agree... butt those plastic filters are better than no filters and a clogged carb 10 miles from base camp is no fun.
  17. C

    9.5 Ready for wet test

    have you tried increasing the idle speed with the side knob. ?
  18. C

    73 Johnson 115 - Run away engine Questions

    better find the kill circuit....and fix it
  19. C

    1955 evinrude 7.5 hp carb and starting

    you can always install a small lawn mower filter on the incoming fule line before the "empty" bowl to keep crud away from the carb
Top