Search results

  1. R

    Need a CDI for a 1979 to 1983 120HP mercury outboard

    your location ?----Agree with above about 120 HP being very rare.----Part # you need ?
  2. R

    97 25hp 2 stroke fuel issue

    Pull off the top plug wire.-----Try and start the motor.-----Repeat with other cylinder.-----Checked reed valves ?----Checked flywheel key ?
  3. R

    Johnson 90 hp fuel line connection

    Correct that is the oil line going to the VRO unit.----Perhaps it was properly converted with a conventional pump mounted directly over the pulse port.-----Fuel pump would be small and mounted directly in front of starter.----Do the compression test.---Post the actual values here.
  4. R

    1993 Johnson 4hp not pumping water

    Testing in a bucket?----Water needs to be 6" above the impeller.
  5. R

    engine miss after installing vro to pre-mix pump

    Then get rid of that fuel pump.-----Sounds like it is clearly the issue !
  6. R

    Changing throttle styles

    Are you sure the Morse does not have a fast idle feature ?
  7. R

    engine miss after installing vro to pre-mix pump

    Carburetor bowls warped ?
  8. R

    Nissan 40hp outboard (NS40C) 1988 - Alternator???

    Usually coils under the flywheel charge the battery.-----Read voltage on battery with motor not running.-----Read voltage on battery with motor at fast idle.
  9. R

    1982 25hp top cylinder won't fire

    Post #4
  10. R

    1992 Evinrude 150 aluminum in cylinder

    After removing the aluminum, you need to check and make sure cylinder is still round.
  11. R

    Haul repair

    Couple of layers of 1708 on the INSIDE and about 6" wide will do the trick.----Any pictures of these little mistakes?
  12. R

    Serial number look up

    An 89 would have 2 carburetors !----I doubt there are 4 PUMPS on this motor.------So stop guessing and post some pictures !
  13. R

    engine miss after installing vro to pre-mix pump

    Vapor separating tank------Your motor does not have that item !
  14. R

    1992 Evinrude 150 aluminum in cylinder

    Step #2 would be to determine the cause of the failure and make correction.-----Otherwise it will fail again in short order.
  15. R

    85 force lower unit drain plug

    I think these use the 3/8-16 NC thread.----So not a fine thread !
  16. R

    12 ft lonestar 9.5 johnson

    Should plane out easily.----My bet is that it is running on 1 cylinder.-----Does spark jump a gap of 1/4" on both leads , yes or no ?------
  17. R

    1992 Evinrude 150 aluminum in cylinder

    Step #1 is to take the motor apart.
  18. R

    1993 Johnson 4hp deluxe

    In Canada----evinrudeparts.ca----Or----Iboats----right here.
  19. R

    85 force lower unit drain plug

    I do not like the drain plugs that need an Allen wrench either.-----Using a small punch will remove this screw !
  20. R

    85 force lower unit drain plug

    I doubt that the drain screw is a pipe thread !!!-----And the screw has a gasket , doubt that PB blaster will help here !
Top