Search results

  1. R

    Will a 2001 tiller from a johnson 25hp work on a 1977 35 hp johnson

    I do not believe the tiller from a 2001 will work on a 77 model 35 HP.
  2. R

    Will a 2001 tiller from a johnson 25hp work on a 1977 35 hp johnson

    Not a direct swap.----And is the 2001 a 3 cylinder motor ?
  3. R

    1973 4hp Evinrude

    And the 1.5 / 2 / 6 / 18 / 20 / 25 / 28 / 30 / 33 / 35 / 40 HP all used this simple magneto from about 1950 to 1990.-----An elegantly simple unit.
  4. R

    1973 4hp Evinrude

    Nonsense ^
  5. R

    Starts and idles fine, but cannot get full speed (1985 Johnson 140 hp - J140TLCO)

    Checked flywheel key ?-----Does spark jump a gap of at least 3/8" on all leads ?
  6. R

    1973 4hp Evinrude

    Picture / part# / exact location of this ---" ground strap "---Would help you.
  7. R

    Need help

    I have some friends that can help you.-----But it takes more than one person.------Takes more than 1 million $$ -----Takes more than one button to start one of these places.
  8. R

    1973 4hp Evinrude

    I don't think so !
  9. R

    1970 Evinrude 18hp Trottle issue

    A proper test is done on a MERC-O-TRONIC magneto analyzer.-----I never check for ohms on coils.------If spark does not jump a 1/4" gap or more replace them.----If coils are cracked , replace them.
  10. R

    Starting Delay 1986 Johnson 150 HP Crossflow V6

    Check neutral switch.----Check ground wire from solenoid the block.
  11. R

    Nissan 6hp won’t lock in reverse ( prop sucks up )

    Problem has existed on many motors.----Check the shift linkages going to the lower unit.-----Like just needs adjusting.
  12. R

    100hp falters

    Low crankcase compression??-----It is that PRESSURE pulse that drives the fuel pump.
  13. R

    Outboard fuel range

    ???----Need to post what type of boat you are on !-----Is this trip going to take 2 hrs or 10 hrs ?
  14. R

    1973 4hp Evinrude

    Not sure it is a ---" grounding strip"-----What does it connect to ground something out?
  15. R

    96 johnson. Link and sink

    Model # of this motor ?
  16. R

    1969 OMC gears, are they case hardened?

    Is this a 1.5 HP or the 115 HP V-4 engine ?
  17. R

    Bottom cylinder sounds bad 1997 evinrude 3 cylinder

    There have been numerous failures of middle cylinder on these 56 cube blocks.
  18. R

    Need some assistance with J60PLEEB (Johnson 60)

    What work does the motor need ??-----In 1999 there were troubling times for OMC.-----May not find a 99 specific manual.----A 1997 manual would likely be the same.
  19. R

    Upper crank seal.

    I doubt it is the top seal leaking.
  20. R

    Upper crank seal.

    ??---Did you check / replace the oil recirculation line ?
Top