Search results

  1. D

    Trim ram maxium extension

    Volvo SX drives/transom assys do not use a trim limit, they only have a sender for the gauge located on the stbd side of the gimbal ring. The operator is required to monitor the gauge to prevent the drive from going to high. That said if you feel the drive isn't up/out enough to safely trailer...
  2. D

    1999 7.4 (L29) only hitting 3400RPM at WOT

    yeah, op's engine is an efi mefi controlled ignition/fuel system. base timing mode will usually advance throttle automatically, if not 1500 rpm is considered spec for timing on these motors. 1800 may be a little high but won't hurt anything 454 can handle close to 40 degrees advance at higher...
  3. D

    1989 four winns liberator 350 engine no spark!

    i would strongly recommend avoiding this one, have had many fail/not operate properly in the past...
  4. D

    1999 7.4 (L29) only hitting 3400RPM at WOT

    no check vacuum between the fuel pump and the tank, this will tell you how much vacuum the fuel pump is creating to draw fuel from the tank. should be no more than 2 in/hg, any more indicates a restriction between the tank supply and the pump
  5. D

    MerCruiser 3.0 starter question

    if the primary on the starter solenoid is having 12 volts applied and the starter turns then the starter and solenoid are fine. if bypassing the starter solenoid without testing it tells you the motor is good, but nothing about the solenoid you can test the slave solenoid by checking for...
  6. D

    High oil pressure smell of gas in oil

    no such thing as limp mode for high oil pressure, and a carbureted engine does not have a limp mode. some of the thunderbolt five modules have a knock sensor most likely the engine is flooding out from an improperly tuned carb or carb in need of a rebuild. this would account for fuel...
  7. D

    1989 four winns liberator 350 engine no spark!

    you can do as you please but if all you need is an ignition sensor there's no reason to abate the thunderbolt system. it's pretty much the best stock marine electronic ignition system available
  8. D

    1989 four winns liberator 350 engine no spark!

    voltmeter red lead to wht/red lead coming from ignition module black meter lead to good ground, key on should see 12 (+) volts with meter still attached hold the wht/grn wire from module to good ground and see if voltage drops momentarily then returns to 12 (+) volts - this will tell you the...
  9. D

    Mercruiser dipstick tube doesn't fit with new pan

    merc tube is longer to allow one to exit the oil from the pan using a vacuum pump you could cut the merc tube to fit but the dipstick may not seat all the way due to pan differences, plus you couldn't vacuum all the old oil out
  10. D

    1986 merccruiser weird noise

    when was the last time you pulled the drive?
  11. D

    Mercruiser 3.0 squeal keeping engine from starting

    have you looked under the dist cap? engine turning over smooth like that but hardly running could be a timing issue, like a broken/bent rotor tang?
  12. D

    1999 7.4 (L29) only hitting 3400RPM at WOT

    okay, have you verified timing is advancing? should check fuel pressure at wot under a load and still a good idea to check fuel system vacuum at the same time 454 in a 23 foot sea ray? that boat should do 50 mph easy with more to go
  13. D

    Kills at midrange throttle settings

    the coil is usually the LAST ignition component to fail. that said i have found faulty coils but that is after most other components have been tested/replaced like ad said, check your carb/fuel system first, then you can focus on the ignition system
  14. D

    Mercruiser 3.0 squeal keeping engine from starting

    appears you have a definite internal engine issue, first step is to check compression at all cylinders
  15. D

    Bayliner 175 merceriser 3.0 no fuel to carburetor

    could be stuck needle/seat have you verified the fuel pump operation?
  16. D

    1999 7.4 (L29) only hitting 3400RPM at WOT

    did you have the ignition system in base timing mode? fuel pressure sounds about right, iirc spec is 40-43 psi throughout the rpm range should also check fuel system vacuum, no more than 2 in/hg
  17. D

    Mercuiser 3.0 Popped rear core plug

    yes the cooling system isn't building enough pressure in the block to allow exit out the exhaust once you have the plug installed it's in your best interest to pressure test the cooling system to check for additional leaks
  18. D

    Mercruiser 3.0 squeal keeping engine from starting

    this do this first see if noise goes away
  19. D

    The leg is off

    losing oil out the yoke seal combined with a loud gimbal bearing i'd suspect water getting into the u joint bellows
  20. D

    Missing timing tab? Merc 4.3 2005

    a very handy tool. has rpm function and is much more accurate for setting idle speed than boat tach. will also be spot on for checking total advance and wot rpm
Top