Search results

  1. The Force power

    Carbs leaking fuel 1988 force 125hp

    is that with the choke applied?
  2. The Force power

    Tilting mechanism not working

  3. The Force power

    Tilting mechanism not working

    found an old post with similar issues, this maybe helpful type in the search-bar; 1995 Mercury 25 Reverse Lock Problem
  4. The Force power

    97 mercury force 90hp flooded with 2stroke oil

    True
  5. The Force power

    97 mercury force 90hp flooded with 2stroke oil

    ???? Why not mix the fuel already in the jerry-can(s); they are usually the means of the fuel source already before its goes into the boat's fuel-tank. (unless you fill up at a gas station)
  6. The Force power

    1965 MERCURY 1000E CONTROL BOX

    your welcome :)
  7. The Force power

    Power Trim Service? - Force 120HP 1999

    If it work good....leave it alone. Do you change the oil in your hydraulic car jack if it work?
  8. The Force power

    97 mercury force 90hp flooded with 2stroke oil

    When you syphon out the contents and shake it in jerry can and pour it back in fuel tank add properly mixed fuel/oil (50:1) to fuel tank you should be ok
  9. The Force power

    97 mercury force 90hp flooded with 2stroke oil

    Always always always mix the fuel & oil in jug first before adding to the fuel-tank! Make a new batch & flush this through the carbs run the engine to clean it out
  10. The Force power

    1965 MERCURY 1000E CONTROL BOX

    Here's another one but you have to enable flash player print everything you need because is gone by the end of this year http://www.boatinfo.no/lib/mercury/manuals/mercury_1965-1989_40-115.html#/0
  11. The Force power

    1965 MERCURY 1000E CONTROL BOX

    COOL boat!! Yes definitely a project to bring back to it's glory days! Find a much printed info on this motor and hopefully gurus like merc850 Chris1956 racerone will tune in and they can give you the best info available here is a link for the controls in the meantime...
  12. The Force power

    Merc Trim/Tilt Leak

    I think they mean; do not use the hole for the check-ball when using the spanner wrench
  13. The Force power

    Rip Seven Marine?

    Nah, its slightly under powered :)
  14. The Force power

    Lehr outboard motors?

    There's a couple of them on my lake :) it's a good substitute/solution towards Zero pollution! (unlike me with my 2-stroke)
  15. The Force power

    Tilting mechanism not working

    ##
  16. The Force power

    Replacing stern/transom brackets

    its cast-aluminum it will crack easily, you're chucking them anyway
  17. The Force power

    Replacing stern/transom brackets

    IF..........there's no need to remove the stud, then no (why bother) Just be careful not to damage the stud!!
  18. The Force power

    1965 MERCURY 1000E CONTROL BOX

    IF........the mechanism is not too worn-out???????(controls box) then I would replace all the wiring in it front to back all the way to the engine.(you'll probably have to re-wire/replace wire on the engine side also)
  19. The Force power

    1965 MERCURY 1000E CONTROL BOX

    Just to be clear the power will be 12 volts regardless of how the ignition set up is. Stator v.s. battery power However the ignition power will not be the same (as racerone already pointed out)
  20. The Force power

    1965 MERCURY 1000E CONTROL BOX

    Racerone brought a very solid point to the attention! I apologies for the oversight! Yes for sure a '65 will need battery power to run however the control-box/cables can be used with the right modification to the hook up of the wires.
Top