Search results

  1. C

    Small Flywheel Tool

    do you mean hold... as in while you unscrew the top bolt ?? I use a small 1/4 inch impact screw driver / socket to remove bolts on 3-10 hp engines and they work great . no need to "hold" the flywheel
  2. C

    68 Johnson 9.5

    basics are not always basic to all and that motor does not sound to bad. No expert but I have reworked several 9.5 & most had comp#s in high 60s to low 70s none were speed bombs . these low compression engines were made to facilitate fishing- casting with their flat heads and easy...
  3. C

    1984 70hp Johnson, won't stay running

    try pumping the fuel hose.... does choke open up properly linkages all ok ? carbs cleaned ..yes no ???
  4. C

    1984 70hp Johnson, won't stay running

    choke working... dirty carb(s) bad gas ....??
  5. C

    1976 Evinrude 6hp..only getting spark in one cylinder.

    test coil sparks with a screwdriver in the boot held close to the engine frame.. if OK ...... bad plug
  6. C

    1976 Evinrude 6hp..only getting spark in one cylinder.

    6hp is a great motor and points are also a good system why not reinstall the points clean / gap them properly condenser may be bad keep coil wire away from the cam lobe ! test secondaries... boot to frame 3-7 KOhms depending on coil make
  7. C

    68 Johnson 9.5

    try running with the cowl off.... if much better it may be breathing it's own exhaust due to a poor sealing skirt down below just above the water pump do a compression test and report back what you find. they are low compression engines but 65ps seems a minimum.
  8. C

    68 Johnson 9.5

    see pict. good luck it is only a 9.5 with typically low compression #s good trolling motor and keep that high speed nozzle 100% clean see Leroys http://www.leeroysramblings.com/OMC_9.5.htm
  9. C

    1963 Johnson QD-24B

    when recoiled the small arrow should be lined up with J ZONE for Johnson models
  10. C

    Value of Brand New never used 1978 Evinrude 55 HP 2Stroke outboard 55875?

    well if innards ok depending on a 43 year sleep over I would start at nothing under 5000$ and wait for nibbles. nice find !!
  11. C

    69 Evinrude 6Hp correct spark plugs

    I think j6 is a bit hotter than J4 and better for trolling
  12. C

    Evinrude choke override spring 0318445

    certain it is a 1979... mdl # does not show up easy if really stuck you can probably just make one out of piano wire . I made one up for the choke on my 9.5 HP ... spring design is vey simple to reproduce and for the price you can order a whole box of spring.. piano wire ...just...
  13. C

    Johnson 40e 74s blowing fuses

    strange that it ran with that switch .. in any event you must now track down the source of the low resistance to ground which is causing the fuse to blow . the fuse has a B+12v side ... the other being the load side. connect one VOM lead to the LOAD side of the fuse and the other...
  14. C

    1976 Johnson 25hp No spark

    ignition potential problem areas...
  15. C

    Question about service manuals

    actually running with the cowl off is good in the sense that more fresh air will reach the top mounted carb ... yet running in a drum could certainly cause carbon monoxide death...to the engine notwithstanding other issues running with the choke is imho more indicative of a dirty...
  16. C

    ‘69 Evinrude 6 Shifting Rod connecting problem

    try figure 8s on 150 grit paper over a plate glass till the the cover is nice and shiny .
  17. C

    Question about service manuals

    this covers most problem areas if the innards are ok http://www.leeroysramblings.com/OMC_9.5.htm just as info... the large round exhaust skirt above the water pump sometimes will let fumes go up into the powerhead area and cause engine suffocation as fumes get sucked in the carb.
Top