Search results

  1. Scott06

    cover prop for winter?

    There is a roughly 1/4” hole in front of nose cone of lower unit make sure that is clear and it will all drain. Pour a little af down the center of the prop you should see it drain.
  2. Scott06

    Old ford 302 no spark

    Unless there is a LFW, loose effing wire , might check wire from points to negative side of coil for chaffing. Can ground out the points and effectively kill the spark
  3. Scott06

    Volvo Penta 5.0GI to 5.7 swap

    i got my base engine from Michigan motors six years ago. A new 5.7 base engine was about $3k or 3200 then. of course a new engine will be more than the rebuilds you mention. on the injectors i dont think so as long as they are clean and work. You may want to cross check this with who ever does...
  4. Scott06

    Volvo Penta 5.7 GSi PLKD timing mark out of scale

    Yes fluctuating idle and stall is typically the IAC valve or the filter for it. i thought yours was throttle body injected not mpi, didnt think that has a iac
  5. Scott06

    Volvo Penta 5.7 GSi PLKD timing mark out of scale

    Verify you don’t have a voltage drop during cranking. Id think if you have really good spark it would start instantly. maybe dump a little gas down the throttle body then see if it changes the way it starts . If it gets better that points to fuel issues, if no change would think that means...
  6. Scott06

    Volvo Penta 5.0GI to 5.7 swap

    Yeah i was hesitant to suggest it cause it can open a can of worms thread wise. In crate form i think a 383 is like $1600 more. If you want to build your own as Scott points outyou can put it together for similar price. Depends on what you want to do. I bought a partial engine (crate plus...
  7. Scott06

    Volvo Penta 5.0GI to 5.7 swap

    No you wouldn‘t you would do a big block… oh wait you already did…
  8. Scott06

    Old ford 302 no spark

    Don't keep us in suspense, what was it ?
  9. Scott06

    Bayliner 265 (2002 vs. 2003)

    I think description was wrong link had pic of engine compartment https://www.yachtworld.com/yacht/2003-bayliner-265-ciera-8073206/ shows a 2 bbl 5.0
  10. Scott06

    Old ford 302 no spark

    Look at the way this is wired up. https://bzerob.com/library/ford/ford-starter-solenoid.html this shows the two ways the coil gets power, one in run goes through resistance wire assuming your solenoid is the same pay attention to grounding of body on solenoid i susoect you are not taking...
  11. Scott06

    Milky oil Mercruier 3.0 / how to pressure test engine ?

    Yes Rick means as an alternative to acetone test, so you don't have to remove the manifold as you would for acetone testing. Make a blank off plate for where the elbow goes and pressurize with air when you do the block testing.
  12. Scott06

    Volvo Penta 5.0GI to 5.7 swap

    Absolutely worth it, per AD's comments you may want to consider a 383. I repowered a 21 ft Sea Ray six years ago, had a 4.3 that PO didn't winterize. The boat was also offered with a 5.0 from factory, so that's what I went back in with... I was thinking a 5.7 would be too much for the boat, I...
  13. Scott06

    Volvo Penta 5.0GI to 5.7 swap

    There are companies that reprogram them like https://obd2allinone.com/mefituning.asp https://www.boatunlimited.com/ I'm sure there are others might be worth looking around before you buy
  14. Scott06

    Milky oil Mercruier 3.0 / how to pressure test engine ?

    to pressure test the cooling system you need to take the water inlet hose and water outlet hose to the manifold , plug them with pipe fittings such that you can pressurize with compressed air and have a pressure gauge. you should also check the manifold and exhaust elbow as these can leak...
  15. Scott06

    New Engine Replacement - Engine Died and Hydro locked after 5 hrs!?

    Lou I really respect your experience but on his account I don’t think you are not correct I had flappers in my 91 merc 3.0 fail looked like over cooked bacon . Boat never overheated. Point is they are not the fail safe. Honestly in my option they don’t do much except cover a gross wave coming up...
  16. Scott06

    New Engine Replacement - Engine Died and Hydro locked after 5 hrs!?

    Sounds like the cam you have is less aggressive than the stock VP so should be ok. Unless you have exhaust leakage or a crack in head which doesn’t really fit what you are seeing , i also suspect you have more weight in back of boat for what ever reason, necessitating higher risers. That you’ve...
  17. Scott06

    Please Help Troubleshooting Volvo Penta 3.0 GLP-E

    Deleted comment old thread you would be better served by starting your own new thread …start with what your boat is doing …
  18. Scott06

    Searay 180 Alpha one fuel pick up fitting replacement

    Nitrogen or argon are inert and readily available at welding and bottle gas suppliers alternatively suck the gas out with a pump and rinse the tank out then you can do what ever you need to including welding
  19. Scott06

    3.0 litre Mercruiser sterndrive oil issue

    Likely the second one is the oil pressure switch. The alarm that sounds briefly when you start is because there is no oil pressure yet until the engine gets going. same alarm sounds for low oil pressure, low drive lube, or engine over heat. the alarm should have sounded when you lost oil...
  20. Scott06

    3.0 litre Mercruiser sterndrive oil issue

    If some of the nipple is sticking out put a set of vice grips on it. Otherwise use a screw extractor or easy out on it
Top