Search results

  1. R

    Mystery small Johnson 65? 6hp?

    Yes there is a friction adjustment.----Usually you can use a screwdriver or socket on it.----Also has a spring.----If you can not find it ask again.
  2. R

    60hp 4 stroke TPS setting

    Make / model #
  3. R

    1976 25 hp, no spark

    Correct.-----I think it is " hockey stick " tape.----I use a rope on the flywheel to test for spark.
  4. R

    1976 25 hp, no spark

    Tested the driver coil ??-----Are breaker points absolutely clean and set properly ?----Find the reason for the issue.----In 50+ years I have never needed to turn a motor with a drill.-----I do not use the " crank and hope " technique!!
  5. R

    Loss of power, won't plane

    I would not use the bearing as pictured in post #42-----Why the new rod bolts as suggested.
  6. R

    Murcury 850 thunderbolt stator

    Do a complete evaluation on the motor before spending any beer tokens.
  7. R

    how do you run an OMC TUFM-21C out of the water?

    See post #3
  8. R

    how do you run an OMC TUFM-21C out of the water?

    I agree.----But perhaps this is a custom and one of a kind.----Pictures would help.
  9. R

    how do you run an OMC TUFM-21C out of the water?

    But the party insists it is a Chrysler ??
  10. R

    Murcury 850 thunderbolt stator

    Not sure where you are looking.----Just a few clicks and I find a stator with 2 yellow wires.---Ouch--$450 or so.
  11. R

    1973 9.5 Johnson

    If the coils are original they will be cracked.----All of this vintage Johnson / Evinrude have had coils replaced if they were regular runners.-----Only one way to find out and that means removing flywheel !
  12. R

    1972 Johnson 25 HP no spark

    The starter is assembled wrong in my opinion.
  13. R

    1972 Johnson 25 HP no spark

    Agreed those dock busters had 2 pinions to actually run the motor in reverse.-------There was no reverse gear on those to rob them of power.
  14. R

    Question on starting an outboard. And fuel line question(s)

    Turn the handle against the neutral interlock.-----Confused ??----Take the cowling off and see how this works !
  15. R

    10r77a rich lean adjust

    Going to be blunt here, as usual.-----You are looking in the wrong place talking to the wrong people.------Order a seal kit for a 1992 model 9.9 / 15 HP.----Parts such as the gearcase seals are the same year after year !!!----If in Canada order a seal kit at ---evinrudeparts.ca----Stuff is...
  16. R

    1973 9.5 Johnson

    Pop the flywheel off.-----Use the 3 threaded holes in the flywheel for a puller.----They are 1/4-20 NC thread.----Do not put screws in too far.-----Coils might be cracked.-----Install new water pump impeller before launching the boat.----Is the flywheel nut loose or is that the wrong nut...
  17. R

    Vintage Mercury Cooling Issue

    Likely just need to clean the breaker points.----That is if spark is the issue.-----These motors are so simple to trouble shoot.-----Motors sold privately usually have issues as well.
  18. R

    88' Force 85hp lower unit oil viscosity

    Is the oil level correct ?----Filled from bottom til oil came out the vent ?---Did you do any shimming to make sure you have correct tooth contact?----Or just installed the shaft and closed it up ??-----I don't think that oil is the issue here.
  19. R

    Need Model and year for 50's Evinrude

    7520 =1956-----and 7522 is 1957.-----The 15016 is a 1956 model 15 HP.
  20. R

    1989 Mercury 115 fuel/air issue

    Normal for the bulb to be soft after motor has run.----This fact confuses many people.-----Sparkplugs have nothing to do with testing the ignition.-----Does spark jump a gap of 3/8" on each lead , yes or no ?---Do you push the key in and hold it iin while cranking it over ?-----When motor fires...
Top