Search results

  1. R

    water tank for 25hp Mercury 2-stroke, not peeing

    Water must be 8" above the impeller for testing in a bucket.
  2. R

    1982 Johnson 9.9 water pump

    But you must line up the notch with the hole before you put the bolt in !!----And most out boards need to be running for proper shifting.----Or on a stand you need to turn the propshaft when shifting.-----Get this right or you will be spending beer tokens on parts !!
  3. R

    Help identify this cowl

    Look some more !!----It is clearly listed for me.
  4. R

    Tilt/trim

    Aftermarket is about the only way.----Look for one----CMC trim units----Not cheap but,
  5. R

    Help identify this cowl

    Look for it in the 2001 model year.----Yes , you will find a 40 HP 3 cylinder there.
  6. R

    1982 Johnson 9.9 water pump

    You operate the shift handle to push the rod DOWN all the way.----You pull the lower rod all the way UP , while turning the prop.-----This give you ample room for tools to connect up the shift rod.-----When it is together it will shift correctly !!
  7. R

    1982 Johnson 9.9 water pump

    The water tube must be installed into the midsection first.-----Flywheel must be turned slowly while pushing lower unit up.----Shift rod notch must be lined up with the hole before putting the bolt in.
  8. R

    1958 Evinrude 7-1/2 Fleetwin carburetor overhaul

    Make sure you get plug wire with a METAL CORE .---Available at most marine shops.
  9. R

    Starboard cylinders overheating, but no thermostat installed

    Outboard motors need a new impeller if you do not know how old it is.----And a new one about every 5 years or so.
  10. R

    1977 25HP Evinrude cutting out.

    Check the reed valves.
  11. R

    1958 Evinrude 7-1/2 Fleetwin carburetor overhaul

    There is no oil seal , rubber or carbon.----Just a slinger.----Do not worry about the notch.
  12. R

    Mercury 40 hp two stroke

    Neutral switch in the control box.
  13. R

    Is anyone else seeing odd behavior of the site?

    Behaves one minute and not the next.----Typical computer and IT stuff.----Always making changes.
  14. R

    Starboard cylinders overheating, but no thermostat installed

    replace the diverters.
  15. R

    1973 Mercury 850 Won’t Idle

    Make sure that the reed block are located on the dowels.
  16. R

    Starboard cylinders overheating, but no thermostat installed

    Test compression with another gauge.----At 90 PSI they appear to be low.
  17. R

    1984 OMC 200HP compression

    edited
  18. R

    Help! 1968 33 HP Evinrude

    The only thing that could go wrong is the diaphragm in those pumps.----Easy / cheap ( $10 or so ) to replace.----Run the carburetors dry for extended storage.----An empty carburetor stays clean and will require a minimum of maintenance.----New float valve once in a while.----Used parts are not...
  19. R

    1992 70hp Johnson - electrical issue with Trim and Start and gear shaft position fail

    Used parts are easy to find.----But it depends on your location.
  20. R

    '88 Force 15 "Where's the thermostat?"

    Is your motor an 88 model ?-----Model # is ??
Top