Search results

  1. R

    1966 Johnson 6hp magneto timing issues

    Roadrunner I have repaired many of these motors !!-----I have those factory timer fixtures or I use the flywheel itself for timing with a meter.-----These magnetos are very very simple to me.
  2. R

    1988 Stratos 189v with Evinrude Xp 200 Fuel pump not getting power.

    What fuel pump ?-----The VRO pump has wires going to it but that is only for an alarm .----Alarms for no oil flow.-----The VRO pump if it is still in service runs with PRESSURE pulses from the crankcase.----Are you pushing the key in while cranking it over for a cold start ??
  3. R

    1967 Johnson 20 FD21-r Model

    Run this motor on 50:1 gas oil mix.----Use a quality oil.
  4. R

    why won't the flywheel turn over manually

    Flywheel magnets ????----Screw loose under the flywheel ?
  5. R

    1967 Johnson 20 FD21-r Model

    Agreed ----Never leave it empty over the winter !!
  6. R

    1966 Johnson 6hp magneto timing issues

    In the past I have developed blisters on my finger tips in explaining that the opening of the points is critical to get peak spark.----Actual gap does not matter , within reason of course.-----It is called a MAGNETO and it is a simple device that many folks struggle with.-----You can buy the...
  7. R

    Rec gas prices???

    If you price out coffee at your local " hot cup outlet "----You might find it to be ~ $20 / US gallon.-----Folks lining up every day.------Thing is you do not buy it in large quantities.
  8. R

    Smoke from the Alternator!

    Replace alternator.-----Make sure battery connections are correct.-----Electrical issues , perhaps leading to a fire will ruin your day.
  9. R

    1966 Johnson 6hp magneto timing issues

    The points always open with the mark on the flywheel between the 2 vertical marks on the magneto plate.-----This is the timing of the magnets and heels of the coil !-----Timing relative to piston position is fixed by the linkage that rotates the magneto plate.-----No user adjustment...
  10. R

    1967 Johnson 20 FD21-r Model

    Why not a 50:1 mix on this fine motor ???
  11. R

    1966 Johnson 6hp magneto timing issues

    Points are not used to change timing !-----This thing is a simple magneto and points are timed to get the STRONGEST spark.-----The timing of spark before or after TDC looks after itself with the linkages.---- The tip of the slow speed needle broken off by chance.----It is known to happen on...
  12. R

    Cracked holder/carrier assembly

    The early HONDA motors ( 75 and 90 HP ) used Mercury lower units
  13. R

    2003 Mercury 200 2 Stroke carb running hot at idle. New impeller, new thermostats

    When on the muffs with motor stopped the impeller itself BLOCKS the flow of water to the engine.
  14. R

    Lifting 20ft CC for bottom paint.

    Move boat back 2 feet .-----Drop trailer tongue. with tongue jack.-----Block up rear of the boat.-------Raise tongue.-----Use a 5 ton jack on the keel near front of boat and raise boat off the bunks.----Add extra blocking for safety.-----Mark / measure position of bunks.-----Remove bunks.
  15. R

    Lifting 20ft CC for bottom paint.

    If you just need to lift a few inches to remove the bunks then no need to move the trailer away.
  16. R

    1967 Johnson 20 FD21-r Model

    Replace the impeller.-----No gaskets needed.------Change gear oil.------Inspect thermostat.-----The thermostats are often missing or stuck open.----Run with 50:1 gas oil mix.
  17. R

    why won't the flywheel turn over manually

    How did the motor run for you last season ?-----Checked the oil level in gearcase?-----Oil level in the crankcase ?----How fast was it running when it quit ?----Make any noises ?
  18. R

    Lifting 20ft CC for bottom paint.

    Pull boat backwards on the trailer 2 feet.-----Drop the trailer tongue down.------Put blocking under the transom.------Raise tongue of trailer.------Use a 5 ton jack under the keel near front of boat.------Raise front of boat.-----Move trailer forward.----Lower boat onto trailer and move the...
  19. R

    1989 xr4 150 that sat 3 years issues.

    Maybe it is just meant to be a primer pump.----Lazy mans way to get rid of the hand squeeze , bulb thingy.-----Make sure you understand your fuel system before your first fishing adventure !
Top