Search results

  1. R

    1966 Johnson 6hp magneto timing issues

    The Evinrude models show a short and long shaft for 1966.-----So of course they made those in Johnson as well.----Some internet parts places do have errors and omissions !
  2. R

    1966 Johnson 6hp magneto timing issues

    I think the owner needs to find the high speed jet.-----Not shown in above picture.
  3. R

    Rec gas prices???

    Or shop on line and have electric vehicle drop goods on your doorstep.------People are learning that shopping in person is too much work, takes a lot of time.
  4. R

    1966 Johnson 6hp magneto timing issues

    He says it runs for a few seconds and quits !
  5. R

    Transom fix

    Time to do a good inspection of this boat.----I think you might find more issues.-----What year is the boat.-----What year is the motor ?
  6. R

    OMC 800 Tilt - Need help!

    It takes a lot more current for UP.------Motor may have thermal overload protection.
  7. R

    2020 Yamaha 115 vmax cooling issue

    Rubber is vulcanized by heat when in a mold.-----The process still carries on ( slowly ) once part is out of the mold.-----Hence the question about how hot this motor gets in sunlight on the hoist !
  8. R

    1989 xr4 150 that sat 3 years issues.

    ??----Your motor has a fuel bleed system , they are the small oil lines.------And it also has an oil recirculation hose from bottom of the block to near the top bearing.-----The fuel pump has hoses going to it for PRESSURE pulses from the crankcase.-----Those pulses operate the simple...
  9. R

    Short shaft motor on long transom

    I am not sure that they market motors for 17" transoms.-----Many folks are confused by the term short and long shaft.-----It refers to the height of the boat transom.----Thus 15" motor is designated a short shaft and 20" is a long shaft.-----It is not some dimension on the motor itself.-----And...
  10. R

    1966 Johnson 6hp magneto timing issues

    Sorry ------ I can not see , feel or hear your motor.---------Sounds like the carburetor is plugged.-----Take it apart again ?-----In the very bottom of the float bowl you will find the high speed jet.----Way inside the drain plug.-----All the fuel must go through it.-----It is about 15 mm long...
  11. R

    OMC 800 Tilt - Need help!

    Loosen the 4 bolts on the intermediate bracket pivot bearings.----Test.-----Perhaps jammed with corrosion.
  12. R

    1966 Johnson 6hp magneto timing issues

    Points are set with the meter to open at the correct time.----It is relative to rotation of flywheel and coils.-----Timing of spark relative to position of piston is all factory set by linkages with no adjustment needed.-----So knocking might be the coils rubbing on the flywheel.------So set...
  13. R

    J6rcrm will shutdown after running for a short time

    Just 3 screws, 2 above the prop.----And one from top at the front.----Just install a new impeller.------That motor does not have a WARNING system or an overheat SHUTDOWN feature.-----It would run till it was too late and major damage is done.
  14. R

    Glastron GT-150 Ideal Prop for Slalom Skiing

    Most props have diameter and pitch marked or a part #.----Look for them.
  15. R

    Is this normal wear on a distributor belt?

    Lapping the tapers is a common procedure.----The flywheel key on most motors is there for setting the timing !-----The flywheel is driven by the locked tapers.-----It must be so!.----On some years of Johnson a 9.9 and 300 HP use the same flywheel key.
  16. R

    J6rcrm will shutdown after running for a short time

    What happens when you operate the manual fuel pump?----I also recommend that you install a new water pump impeller.-----Replace O-rings in fuel line connecters.
  17. R

    Outboard almost hits transom when trimmed up?

    It is a FORCE motor marketed / rebadged by Mercury for Tracker boat company.
  18. R

    Outboard almost hits transom when trimmed up?

    Can you raise the motor by 1/2" ?----Is it a Mercury motor or an an inline 4 cylinder FORCE ?
  19. R

    Rec gas prices???

    Back in the day when folks had a " grade 6 or 8 and a farm education " everyone appeared to be treated fairly.------Now with university edumacations mankind has learned to screw everyone in sight without a kiss.
  20. R

    Q. Factory : 2022 Mercury 565 racing engine.) & ( Mercury 496 Mag H/O bravo one ) boat spd (Q).

    Hurry ,hurry----Find a shop in your area with a dynamometer.----Have them run a test on your present motor to see what the actual power output is.-----Then decide where / how to spend the beer tokens.
Top