Search results

  1. R

    $50 150hp Gambling project (pics)

    I doubt the boat was parked because a broken steering system.
  2. R

    Olympics

    I was awarded a trophy years ago in hockey.----Most sportsman like player and I played defense.-----.Today I say if I was the referee in some NHL games there would be no one left to play the game after 10 minutes.-----I often said it too.-----Players get a 2 minute penalty doing things on the...
  3. R

    $50 150hp Gambling project (pics)

    Remove bypass covers and inspect pistons and rings.
  4. R

    Piston fit

    So what do your pistons measure 1/2" from bottom of skirt?-----And what do your bores measure just above the ports ?----Post some accurate measurements.
  5. R

    2006 50hp honda serial: BAZS 3600812

    Cable terminal.------About $10 at your Honda dealer.
  6. R

    new to me 1970 Johnson 25hp tiller short shaft. locked up

    Yes they were a flush screw ---10-24NC
  7. R

    2005 Evinrude ETEC 200 no start question

    Ordered a new flywheel ?-----Did you do injectors one at a time ?-----Put them back in the same hole ?
  8. R

    new to me 1970 Johnson 25hp tiller short shaft. locked up

    Somebody struggled with that oval cover in second picture.----Broke the 10-24NC screws and went to 1/4-20 NC in there.
  9. R

    Rotten Boat Factory

    The cost of labor to fix them is the issue.-----Most were not made with good materials.-----And they were never assembled to be repaired.------The sad part is that many similar boats are still being used.-----Folks have no idea what is in the transom or under the floor.
  10. R

    Is it feasible to straighten a prop shaft?

    What motor ?------Was boat on a trailer ?----What boat ?----Did renter put a new prop on ?----Was it bent before this last renter used it ?
  11. R

    Looking for help !

    The flywheel is held on with 5 bolts.------Usually just pries off. ---No puller needed.
  12. R

    1958 7.5HP Johnson prop

    Picture #2 does not show any damage from binding.-------That pin LOCATES the front bearing for oil flow in the bearing.----Look at it carefully.-----So just drill for a second pin.
  13. R

    How to get boat launched daily when Travel Trailer camping?

    Make a rig using some bicycle wheels.----They carry a lot of weight.----Often available free at the landfill.----Hunters use them to carry game out of the woods don't they.----Find a sample using google.----One on sale for $252.99.----Will give you the idea.
  14. R

    Cold Start Procedure - Johnson 99 venom 225

    That model may have the " quick start " function.-----See if that is working.
  15. R

    Cold Start Procedure - Johnson 99 venom 225

    Key is to be pushed in and held in while cranking.------Load test your battery.-----Take starter apart for inspection and ohm test of armature.------Slow cranking can lead to a hard to start motor.
  16. R

    1991 60hp Johnson Issue

    Good luck with your project.-----A cylinder sleeve out of " position " can also be a reason for power loss.
  17. R

    1969 mercury 110 9.8 go fuel pump .

    Newer Mercury pumps may well be part of the carburetor itself.----A Johnson / Evinrude fuel pump is an elegantly easy solution.
  18. R

    1969 mercury 110 9.8 go fuel pump .

    Some will argue------It is very simple to install a pump like one off a 9.9 Johnson / Evinrude.----That is what I would do !
  19. R

    1991 60hp Johnson Issue

    Yes I am aware of those holes.-----The owner of this motor needs to do some organized trouble shooting !!
  20. R

    1991 60hp Johnson Issue

    The ignition parts on these engines are very good and reliable.------Most are replaced needlessly.------What other trouble shooting has been done ?-----Some will argue but compression values are low on your motor.-----I would also load test the battery.----And take starter apart for ohm check on...
Top