Search results

  1. R

    Steering and throttle control

    Depends on your budget.----Contact a dealer like ----evinrudeparts.ca----They might know how many coins it takes.----Give them you payment ID and they might send you the parts.
  2. R

    9.9/15 Front-to-back Armature Plate Movement

    It is a strong magnet and yes you will see that on all of them.
  3. R

    Can anyone tell me what year this motor is?

    The 1966 had the battery powered points distributor.---The 4 barrel carburetor.-----The 67 model had electronic breakerless distributor.-----The 68 model did not have the belt driven distributor.----Picture of the back of the block allows for near instant ( 2 seconds ) identification.
  4. R

    Pressed in hub - remove or find washers?

    You need a hefty press to take that out.----Not sure if a flo-tork kit will fit either.----Is 21" pitch the prop you need ?
  5. R

    1977 Evinrude 25 (25702h)

    edited
  6. R

    flywheel not engaging with crankshaft, Johnson 50hp 1996.

    ^^^^----Applause on the above post.-----The tapers have to be matched using lapping compound.-----That will get you the correct ---" locking fit "----and that drives the flywheel.----The key merely locates the flywheel for correct timing.-----Note on some model year OMC products the same key is...
  7. R

    Speed problems on pontoon

    Model # of the 85 HP?-----Perhaps not prop rated.-----Model # off the 115 HP ?------Is the 115 confirmed to be in good condition ?
  8. R

    1967 Evinrude fisherman runs way to rich

    There was no high speed needle when it left the factory !----But someone may have installed the kit that was available at the dealer.------Simple steps to do.-----Compression test first.---Then test for spark.----Spark must be able to jump a gap of 1/4" or more.----And I believe you need to...
  9. R

    1980 Johnson 25 Driveshaft Seal

    Looks correct to me.----You are aware that the parts book show 2 seals there and they are mounted back to back.---So the other one would have the spring thingy to the oil side.
  10. R

    1977 Johnson 140hp outboard -

    Well---40 volts from the solenoid makes no sense.----Load test the battery.----Inspect battery cables.----Take starter apart for inspection.
  11. R

    Tohatsu 6hp still not broke in having carb issues?

    Run the carburetor dry when done boating.----A dry carburetor does not gum up.
  12. R

    1961 10hp Johnson QD-22 Throttle Problem

    Be an easy fix here.----But we can not see or feel your motor !!
  13. R

    1961 10hp Johnson QD-22 Throttle Problem

    Does the vertical arm move when you operate the shift lever?----Prop must be turned when shifting.
  14. R

    1961 10hp Johnson QD-22 Throttle Problem

    Post pictures of the shift lever.----The area below the cowling where a pin moves that arm.
  15. R

    1961 10hp Johnson QD-22 Throttle Problem

    deleted
  16. R

    Will only idle on fast

    That motor in good condition will idle and troll all day long.-----So something is wrong and it is up to you to trouble shoot.-----Are you the new owner of this motor ?-----Post compression test values.----And check to see if both leads have spark that will jump a gap of 5/16" or more.----Sounds...
  17. R

    flywheel not engaging with crankshaft, Johnson 50hp 1996.

    It would be rare for the 2 cylinder 50 to have a broken crank.---Your description in post #1 sure points to a loose nut / sheared key scenario.------But you right it might be a broken crankshaft.
  18. R

    flywheel not engaging with crankshaft, Johnson 50hp 1996.

    Well----Likely the key is sheared.-----Need a new factory key.----Assemble clean / dry and no lube.---Torque nut to 85 FT-LBS.-----Some folks have been tempted and put grease on the tapers.----Big mistake that.
  19. R

    1984 35hp Mercury, won't go in reverse

    Provide more information.-----Was lower unit off for pump work ?----New to you motor?----It is not fully shifting on the trailer ! Lower unit might have to be removed to line up shift shafts properly.----I am not there to see the simple issue.----Provide information.
  20. R

    Impeller Replacement - Among other things

    Those pumps are very simple.---- Hard to assemble it so that it will not work.----Put boat in water for a proper test.
Top