Search results

  1. R

    1960 Fastwin Gearcase Reseal

    A 60 year old motor likely needs a complete seal kit.----Much cheaper than gears and shafts.
  2. R

    Johnson 9.5 carb

    Your carburetor is leaking.-----Up to you to have a look at the float / float valve.
  3. R

    Johnson 9.5 carb

    The float and float valve need attention.
  4. R

    Johnson 9.5 carb

    Try----evinrudeparts.ca-----Not far from Sudbury.
  5. R

    Johnson 9.5 carb

    A good used flywheel is easy to find for that 1964 / 65 model 9.5 HP.----Your location ?
  6. R

    Johnson 9.5 carb

    Revisit your carburetor work.----The float / float valve are not working properly !----And who used a gear puller on that flywheel instead of the proper puller with 3 bolts 1/4-NC thread ?
  7. R

    Im going crazy! Mercury Keikhaefer Merc 110

    Simple.----Look carefully where the block bolts to the exhaust housing.-----I believe you should be able to see where that passage way goes.----And it will be plugged.----Best to install a new fitting , possibly using that plug on top of the block.---Some hose .----Drill a hole in the cowling...
  8. R

    1995 Evinrude Ocean Pro 200 Carbed 2 stroke Flooding out at speed

    Reeds sticking open when hot is just plain nonsense !---Ignore / social distance yourself from the source of that information -There is a test procedure for VRO oil output.----Your dealer can do this simple test.----You did change the gear oil and you did install a new impeller I...
  9. R

    1960 Fastwin Gearcase Reseal

    A 5/16-NC tap will do it.----But actually the o-ring can be replaced without pulling the bushing.----Or yes the special factory tool ( have 4 brand new ones here ) can be used.-----Using a dremel cutting tool will weaken the shaft seals so they nearly fall out.
  10. R

    73 1150 fuel pump/flow question

    The pressure operated pumps are very reliable.----Rarely fail.----Might need a new $5.00 diaphragm one in a while.
  11. R

    1984 johnson 90hp carb leaking fuel out air cleaner

    A new shift rod cover and gasket is the easiest / cost effective fix.
  12. R

    1984 johnson 90hp carb leaking fuel out air cleaner

    The seal is an o-ring INSIDE that cover.
  13. R

    1989 model 70hp Johnson

    They are not breather tubes at all.----The electric primer valve ( not a pump ) put fuel directly into the airstream ( via those wee hoses ) for starting.---Push key in while cranking to start this motor.----And read a few books / manuals before launching your boat it could save you a lot of...
  14. R

    Gas spewing from Carb

    What do you mean by the ---" secondary butterfly "----Never heard of such a thing on these motors.
  15. R

    87 johnson 30 throttle help

    See post #4
  16. R

    1989 model 70hp Johnson

    Pumps do not operate on vacuum.-----They operate with a pressure pulse from the crankcase.
  17. R

    Is It Worth it

    There is no cylinder head on this motor !----Remove intake bypass cover and have a look at pistons and rings.----Cover usually is 1-1/4" wide X 4" with 3 screws.
  18. R

    1060 Evinrude fisherman 5.5hp

    Maybe the coils are rubbing on the flywheel.----Coils need to be set / adjusted properly.----Factory has a special tool for that.----Visit ----leroysramblings-----For all you need to know on that simple magneto.
  19. R

    Sync cam throttle on 71 Johnson 25hp

    Lots of good fuel pumps are replaced as a wild guess.-----Run with a timing light to see if ignition has a miss.------And I agree a 50 year old motor needs lower unit taken apart for inspection of clutch dog.----No special tools or knowledge needed.
  20. R

    Intermittent Alarm

    Correct ,--- item #26 is the switch.
Top