Search results

  1. R

    Gear Oil Everywhere

    Water level in that test bucket needs to be 10 " higher.------Pump impeller must submerged to work properly.
  2. R

    1996 Tohatsu/Evinrude 9.9 4 stroke oil change

    Found the drain screw yet ????
  3. R

    Driveshaft into Gearcase 1990 4hp Evinrude E4RESR

    Agreed ----Turn gearcase upside down.-----Push up on shaft while rotating the shaft.
  4. R

    Gear Oil Everywhere

    ++++----on the above post.-----But perhaps look for a leaky fuel pump diaphragm too.
  5. R

    1996 Tohatsu/Evinrude 9.9 4 stroke oil change

    The drain plug is at the very bottom of the sump.----It is on the PORT side of the motor.
  6. R

    1979 Merc 2 stroke 4 cylinder 50hp

    One more try.-----Do you hear the choke solenoid clicking?----Turn key to on and push in.---Or operate button to activate choke
  7. R

    1979 Merc 2 stroke 4 cylinder 50hp

    So you are raising the fast idle lever.------Are you pushing the key in or pushing a button for choking while cranking it over ???----Excessive cranking can easily damage the starter so be careful.
  8. R

    Stuck lower unit

    pictures or serial #
  9. R

    Stuck lower unit

    edited
  10. R

    1996 Tohatsu/Evinrude 9.9 4 stroke oil change

    Drain plug is NOT on the STARBOARD side of the motor !!
  11. R

    Carburetor issue with an evinrude.

    Not a factory manual ---often many mistakes in these books.-----Some say these manuals belong in the wee house with the 1/4 moon in the door.
  12. R

    Carburetor issue with an evinrude.

    Should make no difference in the starting ability.----Compression of 90 PSI would mean the motor is worn out here.----What manual do these pictures come from.-----The 79 and 80 model both use the same bowl gasket.----But the pictures you post show them completely different.------So something is...
  13. R

    New member/low idle not working

    Your post means very little without pictures or video of it running.-----The markings on the tiller are only a guide.------Do not go too far from the dock until motor proves to run properly
  14. R

    Problems reconnecting the lower unit

    Just make sure that the notch on the shift rod lines up BEFORE you put the bolt in.-----Then it will shift just like before you took it apart.
  15. R

    Stuck lower unit

    That is another topic but no it does not matter.-----You just have to make sure lower unit and control box are in sync on assembly.-----How many fasteners on your work bench now ?
  16. R

    Sport jet 90

    Find the parts on ------mercruiserparts.com
  17. R

    Carburetor issue with an evinrude.

    The 79 carburetors are likely exactly the same as a 1980 model.-----Good spark and good compression mean nothing.------What are the numbers found with a known to be good gauge ?----And does spark jump a gap of 7/16" when cranking it over ?
  18. R

    1996 Tohatsu/Evinrude 9.9 4 stroke oil change

    Port side of the motor.-----Half way down the motor.-----Level with lower mounts.----Same plug as oil drain for gearcase.----Should be easy to find !!
  19. R

    This might seem like a dumb question ... But!

    There is something wrong with electric choke !-----Try moving the solenoid.-----Or the motor is not drawing enuff air to pull fuel into carburetor throat when cranking.--Nozzle gasket is in place in carburetor ?------Year / HP / Model # of this motor ?
  20. R

    1996 Tohatsu/Evinrude 9.9 4 stroke oil change

    That be funny and strange.-----I have 3 of these motors.----I can find the drain plug !!!!----And the engine oil plug appears to be the same part # as the drainplug for the gearcase.
Top