Search results

  1. flyingscott

    VRO Pump Question

    Are you sure its smaller?
  2. flyingscott

    2004 Mercury 115 2 stroke - oil injection block off plate

    There is doing it right and doing it wrong. Don't need to "fixem" for a living to know that. I will tell you how this one goes when I am done with it. My new 125 that won't need gimmicks to run.
  3. flyingscott

    1975 Johnson 70hp

    Youre speed is normal for that motor and set up. Your motor is powerhead rated , realistically 60 at the prop. I ran that same combo and I would recommend a 15" prop to get closer to 5500. 32 was the best I ever got out of it. If you want significant speed increase get an 86 or newer 70 hp.
  4. flyingscott

    2004 Mercury 115 2 stroke - oil injection block off plate

    I know all about what you did to that fine engine. You literally made it so much worse. Honestly I think you are a cautionary tale on what not to do to an engine. By the way I misspelt Good with GOID not GOLD
  5. flyingscott

    No black/yellow kill wire on 9.9. 4-stroke

    Are you positive tohatsu uses a black yellow wire for a kill circuit?
  6. flyingscott

    2004 Mercury 115 2 stroke - oil injection block off plate

    The 3 and 4 cylinder mercs had goid oil injection systems. No reason to delete them.
  7. flyingscott

    250hp Evinrude tilt Guage not working

    looks like the arm popped out. I believe it is supposed to sit between those 2 posts on the switch.
  8. flyingscott

    No black/yellow kill wire on 9.9. 4-stroke

    look up the wiring diagram for a 9.9 tohatsu.
  9. flyingscott

    cowl air inlet on mercury 9.9.

    It is in the rear of the cowl by the grab handle. Or are you saying it does not run with the hood on?
  10. flyingscott

    2003 Mercury ELPTO won't rev above idle

    Is your throttle cable broken?
  11. flyingscott

    Flywheel magnets

    I don't know, I have the 4 magnet flywheel and the red stator. There is no accessory on lighting on my motor
  12. flyingscott

    Water flow out powerhead

    Should have a 120 degree thermostat and the intermittent stream is normal.
  13. flyingscott

    Flywheel magnets

    Get the manual , because I think the 4 magnet stator has a red stator.
  14. flyingscott

    DESPERATE situation

    Nothing should be under the impeller plate unless you removed it?
  15. flyingscott

    99 Johnson 200 shift/throttle issues with new cable

    do you have the cables reversed ?
  16. flyingscott

    1996 115hp can't get starter to engage

    Are you sure it is spinning fast enough? Clean the bendix.
  17. flyingscott

    2001 150 XR6 missing on even cylinders only

    Does it have a shift switch?
  18. flyingscott

    1996 115hp can't get starter to engage

    Is this a crossflow or a 60 deg looper?
  19. flyingscott

    93 evinrude 25HPOver Heating

    Is the key in the impeller?
  20. flyingscott

    97 evinrude 70hp misfire and wont idle

    Have you tried adjusting the carbs? Are the tops cracked?
Top