Search results

  1. flyingscott

    Oil Injection Kit?

    No there is not.
  2. flyingscott

    Crack in lower unit just in front of prop 25hp Mercury OB

    that has to be welded if it can be
  3. flyingscott

    1985 Johnson 120 Goes WOT then falls on face

    Check for spark when that happens.
  4. flyingscott

    Power pack difference

    They are not different manufacturers. 583773 is NLA and has been superseded by 584028. So you are getting the correct part #.
  5. flyingscott

    1985 Johnson 120 Goes WOT then falls on face

    Put it up on youtube and put the link here
  6. flyingscott

    1985 Johnson 120 Goes WOT then falls on face

    What happens when you pump the primer ball on the fuel line?
  7. flyingscott

    Bottom cylinder won’t fire but still has spark

    I believe that is an xblock looper. That means the portside cylinders use the starboard carbs and vice versa. I believe, if not somebody will be along to contradict me.
  8. flyingscott

    1994 9.9hp Evinrude sparks

    15 yrs ago
  9. flyingscott

    '74 70hp Johnson Won't idle/rough running low speed

    from 11 yrs ago????
  10. flyingscott

    1997 mercury 115 hp

    That is usually when they start to act up when they get warm. Stay away from the inline spark testers. Get one that has an actual adjustable air gap
  11. flyingscott

    How do I remove coils on 1966 Merc 110?

    Small gear puller to pull them off of the laminates. Make sure to bend down the locking tab
  12. flyingscott

    1995 evinrude 90 over heats

    Whats it running wih the thermostas in it? 100 is way to low and is this a looper or a crossflow motor?
  13. flyingscott

    91’ Evinrude 25 not pumping water

    Is the tell tale plugged? Water tube lined up in the pump housing? Key installed.
  14. flyingscott

    Camshaft pulley 8 hp Honda not spinning camshaft

    Is there a rubber hub in that pulley?
  15. flyingscott

    1986 Mariner 8hp 6G1 won't idle without choke

    Clean your carb again and make sure you blow air through all the passages.
  16. flyingscott

    Seeking assistance with Mercury outboard 25HP, detached from boat

    Put up a pic of the ignition module.
  17. flyingscott

    Qu about marking on 30HP gear case

    yes it should be. Easy to check put a mark on the prop shaft and turn the drive shaft. Drive shaft should turn 2 times for 1 of the propshaft.
  18. flyingscott

    9.9 evinrude wont idle

    What about the points? You should have to turn the throttle up in neutral to start it. Does spark jump a 1/4" air gap yes or no? Is the needle bearing in? Have you tried adjusting the carb? Float set paralell to the body when it is upside down?
  19. flyingscott

    Qu about marking on 30HP gear case

    Its your gear ratio. 13:26 = 2.00-1
  20. flyingscott

    Basic fuel questions

    You need to clean your whole carb. What motor are we talking about here? Does it have a choke or a primer? It sounds like your idle circuit or main jet is still plugged.
Top